Samsung NX60A6711SS/AA Installation Guide - Page 22

Installation instructions Checking the flame quality: All combustion flames need to be visually checked to determine their flame quality. 1. Soft blue flames-Normal for natural gas 1 operation. 2. Yellow tips on outer cones-Normal for LP gas operation. 3. Yellow flames-Abnormal for any gas 2 operation; call for service. NOTE 3 If burner flame looks like 3, the range should not be used until it is serviced. Call for service. Normal burner flames shall look like 1 or 2, depending on the gas type you use. Step 9. Final installation checklist You have just completed installing your range. Make sure all controls are in the off position and the flow of ventilation air to the range is unobstructed. The following is a checklist to confirm your range is safely installed and ready for operation. Gas Range Plug Locking screw - Gas line has been properly connected to the range. The gas has been turned on. All connections have been checked for leaks. - Range is plugged into the properly grounded electrical receptacle. - Approved anti-tip bracket is properly installed and engaged with the range. - Range is leveled and is firmly sitting on a solid, level floor. - Gas surface burners have been properly assembled. - All burners have been tested for proper operation. - FOR INSTALLER ONLY-Check and/or adjust the broil and oven burner flames as described on pages 21-22 in this manual. Adjusting the oven burner air adjustment shutters Air adjustment shutter All oven burners have an air adjustment shutter. The purpose of the shutter is to regulate the flow of air to the flames. Properly adjusted flames should burn steadily with approximately 1-in of blue cone. The flames should never extend past the edge of the burner baffles. Even though these are preset at the factory, they should be checked and, if needed, adjusted periodically to ensure efficient operation. Installation instructions 22 English Install_NX60A6_DG68-01337A-00_EN+MES+CFR.indb 22 2020-12-30 10:56:14