Samsung NX60T8711SS/AA Installation Guide - Page 23
Step 8. Check the ignition of surface burners, English 23, To turn on a surface burner
View all Samsung NX60T8711SS/AA manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 23 highlights
Step 8. Check the ignition of surface burners Check the operation of all cooktop and oven burners after the range has been installed and assembled, gas supply lines have been carefully checked for leaks, and electrical power cord has been plugged in. All surface and oven burners have electronic ignition. To turn on a surface burner: 1. Push in and turn the control knob for that surface burner to the Lite position. The 2 "clicking" sound indicates the electronic ignition system is operating properly. The burner will light in about 4 seconds, after 1 the air has been purged from the supply line. 2. After the burner lights, turn the control knob to the desired setting. The "clicking" sound will stop and the flame height will change from Max. to Min. during turning the control knob. 3. Repeat steps 1 and 2 to check the operation of each surface burner in succession. NOTE Place food in the oven after preheating if the recipe calls for it. Preheating is important for good baking results. After the oven has reached the desired cooking temperature, it will beep 6 times. Checking the flame quality: All combustion flames need to be visually checked to determine their flame quality. 1. Soft blue flames-Normal for natural gas 1 operation. 2. Yellow tips on outer cones-Normal for LP gas operation. 3. Yellow flames-Abnormal for any gas 2 operation; call for service. NOTE 3 If burner flame looks like 3, the range should not be used until it is serviced. Call for service. Normal burner flames shall look like 1 or 2, depending on the gas type you use. Installation instructions Install_NX60T9700_BEST_BETTER_AA_DG68-01243A-00_EN.indd 23 English 23 2020-03-26 6:41:26