Samsung NX60T8711SS/AA Installation Guide - Page 24

Installation instructions Step 9. Final installation checklist You have just completed installing your range. Make sure all controls are in the off position and the flow of ventilation air to the range is unobstructed. The following is a checklist to confirm your range is safely installed and ready for operation. Gas Range Plug Locking screw - Gas line has been properly connected to the range. The gas has been turned on. All connections have been checked for leaks. - Range is plugged into the properly grounded electrical receptacle. - Approved anti-tip bracket is properly installed and engaged with the range. - Range is leveled and is firmly sitting on a solid, level floor. - Gas surface burners have been properly assembled. - All burners have been tested for proper operation. - FOR INSTALLER ONLY-Check and/or adjust the broil and oven burner flames as described on pages 22-23 in this manual. Adjusting the oven burner air adjustment shutters Air adjustment shutter All oven burners have an air adjustment shutter. The purpose of the shutter is to regulate the flow of air to the flames. Properly adjusted flames should burn steadily with approximately 1-in of blue cone. The flames should never extend past the edge of the burner baffles. Even though these are preset at the factory, they should be checked and, if needed, adjusted periodically to ensure efficient operation. To check and adjust the oven burner air adjustment shutters: 1. Open the oven door. 2. Remove the oven racks. 3. Remove the oven floor. 4. Press the Bake pad, then the START/SET pad. 5. After the oven has lit, visually check the flames coming out of the upper and lower burners. If adjustment is needed, carefully adjust the air adjustment shutters. The shutters are located at the base of the burner manifolds near the back oven wall. Locking screw To adjust the shutter, loosen the locking screw and rotate the shutter towards the open or closed position as needed. If flames are lifting off the burner ports, gradually reduce the air shutter opening until the flames are stabilized. If flames are too yellow and/or too large, gradually increase the air shutter opening until the flames have approximately a 1-in blue cone. NOTE If the range is set up for natural gas, the flames should burn with no yellow tipping. If the range is set up for LP gas, small yellow tips at the end of the cones are normal. After the flames are adjusted properly, shut off the oven, retighten the locking screws, replace the oven bottom and racks, and close the oven door. Locking screw Installation instructions 24 English Install_NX60T9700_BEST_BETTER_AA_DG68-01243A-00_EN.indd 24 2020-03-26 6:41:26