Samsung RB195BSSB Service Manual - Page 32

Temp Control &Operation Functions 2-3) Water Supply/No Water Supply Evaluation by Ice Maker Sensor - When it passes one and a half minutes after the completion of water supply, it will evaluate Water Supply/No Water Supply by comparing the temp changes of the Ice Maker Sensor on the bottom of the Ice Tray. If the temperature of the Ice Maker Sensor is 35.6 ℉(2 ℃) (5 COUNT)higher when it is measured in one and a half minutes after the completion of water supply operation than when it is measured upon the completion of water supply,it will be evaluated as Water Supply.And, if it is increased by lower than 35.6 ℉(2℃)or decreased,it will be evaluated as No Water Supply. 2-4) Water Supply Operation Spec with Ice Test S/W Input - It will carry out water supply for once regardless of the previous water supply status. - The ice eject standby time after the completion of water supply is the same as that after the completion of the previous water supply regardless of the recognition of Water Supply/No Water Supply. - The number of the previous water supply does not change.In other words, if the number of water supply before the Ice Test S/W is pressed is 3 times, the number of previous water supply after the completion of water supply by the Ice Test S/W is 3 times. ※ Example of Water Supply according to Water Pressure On the Assumption of Room Temp over 18 ℃ Low Water Pressure 5s 5s 1.5s 5s 1.5s 1s Initial 2HR Standby Power On 95+(5)MIN No Water Supply 70+(5)MIN No Water Supply 70+(5)MIN No Water Supply High Water Pressure 5s 58+(5)MIN Water Supply 5s 5s 95+(5)MIN 58+(5)MIN No Water Supply Water Supply When ice is not When ice is separated from the separated from the ice tray slot with the ice tray slot with the sensor on it sensor on it High Water Pressure→ Low Water Pressure 5s 5s 5s 1.5s 5s 58+(5) MIN 95+(5)MIN 70+(5)MIN Water Supply No Water Supply No Water Supply High Water Pressure Low Water Pressure 1.5s 1s 58+(5)MIN Water Supply 32