Samsung RSG307AARS User Manual (user Manual) (ver.0.2) (English, French, Spani - Page 13

02 operating ( 6 ) Ice Off (Hold 3 sec for child lock) (7) Ice Type (8) Water Cooling Off Mode If you don't want to make more ice, touch this button. Also, pressing and holding this button for 3 second locks the display panel and dispenser buttons so the buttons can not be used. The Child Lock icon lights up to indicate you've activated the Child Lock function. Touch this button to select your desired ice type. Cubed and crushed ice modes alternate each time you press the Ice Type button. Note that when you push the Ice Type button, you turn the Water dispenser off. Touch this button to dispense water. Note that you cannot dispense water and ice simultaneously. The Water dispenser turns off when you press the Ice Type button. Cooling Off mode (also called Shop mode), is designed for use by retailers when they are displaying refrigerators on the shop floor. In Cooling Off mode, the refrigerator's fan motor and lights work normally, but the compressors do not run, and the refrigerator and freezer do not get cold. To start Cooling Off mode, Touch and hold the Energy Saver button and the Power Freeze button for 5 seconds during normal operation. The refrigerator chime sounds and the temperature display flashes OF OF. To cancel Cooling Off mode, Touch and hold the Energy Saver and the Power Freeze buttons again for 5 seconds. ( 9 ) Ice Off When you touch the Ice Off button ( ), the Ice Off icon lights and the Ice Maker stops making ice. We recommend you stop ice making if the following occur: - There is enough ice in the ice bucket. - You want to save water and energy. - Water is not being supplied to the refrigerator. If the ice maker function is ON, and the water line is not connected, there will be a water valve noise from back of the unit. Press the Ice Off (Hold 3sec for child lock) button ( ) for less than 3 seconds until the Ice Off Indicator ( ) illuminates. If you do not touch any button, the freezer and fridge temperature indicator turn off in a few seconds. If you touch any button, the display lights up again. ( 10 ) Filter Water filter usage The Water Filter icon lights in red when you need to change the water filter. This occurs after you use about 300 gallons of water (which usually takes about 6 months). After install the new water filter, reset the Water Filter icon by touching the Alarm/Hold 3 sec for Filter Reset button for 3 seconds. • If water is not dispensing or dispensing slowly, you need to replace the water filter because the water filter is clogged. • Some areas have large amounts of lime in theirwater which causes the water filter to clog more quickly. operating _13