Samsung RSG307AARS User Manual (user Manual) (ver.0.2) (English, French, Spani - Page 9

Checking The Water Dispenser, Installing The Water Line - filter

Page 9 highlights

01 setting up When the door of the freezer is higher than the fridge Insert a flat-blade screwdriver into a slot on the fridge leg, then turn it clockwise. Connecting to the water supply line 1. First, shut off the main water supply line and turn the ice-maker off. 2. Locate the nearest cold, drinking water line. 3. After connecting the water supply with water filter, turn on water supply and Flush 3 gallons through filter before use (flush approximately 6 minutes). Cold water line Pipe clamp Water line installation kit CHECKinG tHE wAtER DisPEnsER LinE Shut off valve A water dispenser is one of the helpful features on your new Samsung Refrigerator. To help promote better health, the Samsung water filter removes unwanted particles from your water. However, it does not sterilize or destroy microorganisms. You may need to purchase a water purifying system to do that. In order for the ice maker to operate properly, a water pressure of 20~125 psi (pound per square inch) is required. Under normal conditions, a 170 cc (5.75 oz.) paper cup can be filled in 10 seconds. If the Refrigerator is installed in an area with low water pressure (below 20psi), you can install a booster pump to compensate for the low pressure. Installing the water line Connecting the water line to the Refrigerator. There are several items that you need to purchase to complete this connection. You may find these items sold as a kit at your local hardware store. • 1/4" compression nut • copper tubing • plastic tubing • ferrule Make sure the water storage tank inside the Refrigerator is properly filled. To do this, press the water dispenser lever until the water runs from the water outlet. Water line installation kits are available at extra cost from your dealer. We recommend using a water supply kit that contains copper tubing. Check the accessory list below. Hex wrench Clip Refrigerator Plastic tubing (Assembled) Compression nut (1/4") (Assembled) Compression fitting (Assembled) Ferrule (Not supplied) Molded end(Bulb) Compression nut (B) (1/4") (Not supplied) Copper tubing or Plastic tubing (B) (Not supplied) (Not supplied) Household water supply line setting up _09

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64

setting up
_09
01 SETTING UP
When the door of the freezer is higher than the
fridge
Insert a flat-blade screwdriver into a slot on the fridge
leg, then turn it clockwise.
CHECKING THE WATER DISPENSER
LINE
A water dispenser is one of the helpful features on
your new Samsung Refrigerator. To help promote
better health, the Samsung water filter removes
unwanted particles from your water. However, it does
not sterilize or destroy microorganisms. You may need
to purchase a water purifying system to do that.
In order for the ice maker to operate properly, a water
pressure of 20~125 psi (pound per square inch) is
required. Under normal conditions, a 170 cc (5.75 oz.)
paper cup can be filled in 10 seconds.
If the Refrigerator is installed in an area with low water
pressure (below 20psi), you can install a booster pump
to compensate for the low pressure.
Make sure the water storage tank inside the
Refrigerator is properly filled. To do this, press the
water dispenser lever until the water runs from the
water outlet.
Water line installation kits are available at extra
cost from your dealer. We recommend using a
water supply kit that contains copper tubing.
Check the accessory list below.
Hex wrench
Clip
Connecting to the water supply line
1.
First, shut off the main water supply line and turn
the ice-maker off.
2.
Locate the nearest cold, drinking water line.
3.
After connecting the water supply with water filter,
turn on water supply and Flush 3 gallons through
filter before use (flush approximately 6 minutes).
INSTALLING THE WATER LINE
Connecting the water line to the Refrigerator.
There are several items that you need to purchase to
complete this connection. You may find these items
sold as a kit at your local hardware store.
1/4” compression nut
plastic tubing
copper tubing
ferrule
Shut off valve
Pipe clamp
Cold water
line
Water line installation
kit
Plastic tubing
(Assembled)
Ferrule (Not
supplied)
Compression
nut (1/4”)
(Assembled)
Compression
fitting
(Assembled)
Molded
end(Bulb)
Compression
nut (B) (1/4”) (Not
supplied)
or
Copper tubing
(Not supplied)
Plastic tubing (B)
(Not supplied)
Household water supply line
Refrigerator