Samsung SC-D375 User Manual (ENGLISH) - Page 102
Troubleshooting, Dépannage
View all Samsung SC-D375 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 102 highlights
ENGLISH Troubleshooting Dépannage FRANÇAIS Troubleshooting ✤ Before contacting a Samsung authorized service center, perform the following simple checks. They may save you the time and expense of an unnecessary call. Dépannage ✤ Avant de contacter le centre de service technique agréé Samsung, effectuez les vérifications élémentaires suivantes: Vous pourrez ainsi vous épargner un appel inutile. Self Diagnosis Display Auto-diagnostic Display Blinking Informs that... Action slow Tape end! slow Tape end! no No Tape! slow Protection! slow ....D slow L C R slow The Battery pack is almost discharged. Change to a charged one. When the remaining time on the tape is about 2 minutes. The tape reached its end. Prepare a new one. Change to a new one. There is no tape in Camcorder. Insert a tape. If you want to record, The tape is protected from recording. release the protection. The Camcorder has some mechanical fault. 1. Eject the tape. 2. Set to OFF. 3. Detach the battery. 4. Reattach the battery. * If unresolved contact your local Samsung service center. Moisture condensation has formed in the Camcorder. see below. Moisture Condensation I If the Camcorder is brought directly from a cold place to a warm place, moisture may condense inside the Camcorder, on the surface of the tape, or on the lens. In this condition, the tape may stick to the head drum and be damaged or the unit may not operate correctly. To prevent possible damage under these circumstances, the Camcorder is fitted with a moisture sensor. I If there is moisture inside the Camcorder, (DEW) is displayed. If this happens, none of the functions except cassette ejection will work. Open the cassette compartment and remove the Battery. Leave the Camcorder for at least two hours in a dry warm room. 102 Affichage Clignotant donne les informations suivantes... Action lent Le bloc-batterie est presque déchargé. Remplacez-le par un bloc chargé. Tape end! lent Lorsque le temps restant sur la cassette est d'environ 2 minutes. Prévoyez une nouvelle cassette. Tape end! aucun La cassette est en fin de bande. Remplacez-la par une nouvelle. No Tape! lent Il n'y a pas de cassette dans le caméscope. Insérez une cassette. Protection! lent La cassette est protégée contre l'enregistrement. Si vous voulez enregistrer, retirez la protection. ....D lent Le caméscope présente un défaut 1. Ejectez la cassette. L mécanique. C R 2. Eteignez le caméscope. 3. Retirez la batterie. 4. Reconnectez la batterie. * Contactez votre centre de service après-vente SAMSUNG si le problème persiste. lent De la condensation due à l'humidité s'est formée à l'intérieur du caméscope. voir ci-dessous. Condensation due à l'humidité I Si le caméscope passe sans transition d'un endroit froid à un endroit chaud, de l'humidité peut se condenser à l'intérieur du caméscope, sur la surface de la bande ou sur l'objectif. Dans ces conditions, la bande risque d'adhérer à la tête vidéo et d'être endommagée ou l'appareil risque de ne pas fonctionner correctement. Pour éviter d'éventuels dommages dans ces conditions, le caméscope est équipé d'un détecteur d'humidité. I En cas d'humidité à l'intérieur du caméscope, (DEW) s'affiche. Si cette éventualité se produit, aucune fonction exceptée l'éjection de la cassette n'est valide. Ouvrez le compartiment à cassette et retirez la batterie. Laissez le caméscope au repos pendant au moins deux heures dans un endroit chaud et sec.