Samsung SCC-641 Owners Instructions - Page 25

PATTERN This is a replay function so that the MANUAL functions such as PAN, TILT, ZOOM, and FOCUS are played for 30 seconds. ** MAIN MENU ** CAMERA... VIDEO SET... PRESET... AUTO MODE... ALARM SET... OTHER SET... Press [Enter] (AUTO MODE) AUTO PAN ... PATTERN SET 1... RET Press [Enter] PATTERN1 SET PATTERN can be set to 3. Choose 1, 2, or 3 with the left or right key in the "PATTERN SET" and press [ENTER] to get into the PATTERN set up screen. From the moment "PATTERN 1 SET" is gone for 30 seconds, it memorizes the MANUAL movements and after 30 seconds it will return to a higher menu. If you want to finish set up before the 30-second ends, press [ENTER]. ALARM SET It consists of 4 ALARM INPUTs and 3 ALARM OUTs.It can sense an ALARM input from exterior SENSORs and it performs with PRESET or PATTERN function and outputs the ALARM OUT signals. It recognizes the ALARM signal input as an ALARM signal when it continnes more than 150ms for a time and each ALARM movement time is decided depending on it's correspondence to the DWELL TIME of the PRESET and PATTERN connected. ** MAIN MENU ** CAMERA... VIDEO SET... PRESET ... AUTO MODE... ALARM SET... OTHER SET... Press [Enter] ( ALARM SET) ALARM PRIORITY SET.. ALARM IN SET.. ALARM OUT SET.. ALARM PATTERN SET.. AUX OUT CONTROL.. RET ALARM PRIORITY SET ALARM PRIORITY Sets the priority of the 4 ALARM inputs and corresponds to ALARM1 1 ALARM2 2 priority.The priority of the DEFAULT is ALARM1: 1, ALARM2: ALARM3 3 ALARM4 4 2, ALARM 3: 3, ALARM: 4, MOTION: 5.If the ALARM is working at the same time and the priority is the same, it will operate according to the DEFAULT priority.While the ALARM EXIT QUIT is working, it cannot detect MOTION. ALARM IN SET Set the TYPE to "NO" (Normal Open), "NC" (Normal Close), or "OFF" depending on the features of the SENSOR connected. ALARM IN ALARM1 NO ALARM2 NC ALARM3 NO ALARM4 NC EXIT QUIT