Samsung SMT-190DN User Manual - Page 7

SMT-171/SMT-190-ENG 12/8/05 9:40 AM Page 7 USER'S MANUAL Remote Controller ! @ # $ % ^ &* 13. SOURCE Select VGA or Video (Video A / Video B / S-Video) sources. 14. ENTER Select OSD main menu or sub menu. ( Connecting to External Devices E ) The product can be connected to an external device such as 1 Camera, DVR,VCR, etc. 2 3 4 ৻ࠗੑ۱ ଻օ %7%࠺٣য় 5*.&
4-*1 ֣ച %7% 7$3 ࠂࢎ 1. POWER( ) Turns the power ON or OFF. There will be a few seconds delay before the display appears. 2. ID RESET Reset the system id of remote controller. (Default system id is '1') 3. P.MODE Select Picture mode in Video. (Dynamic / Standard / Movie / Custom) 4. AUTO Auto geometry adjustment in VGA Source. 5. RETURN Return to the previous menu. 6. MENU Activates and exits the On Screen Display. 7. LEFT / RIGHT (¥/Š) Increases or decreases the level of active function, and right button is to select OSD menu, left button is previous OSD menu. 8. UP / DOWN (›/‚) Move to OSD menu. 9. NUMBER Button Change the SYSTEM ID for remote controller. With the SYSTEM ID button pressed, entered the desired NUMBER by pressing the corresponding button(0~9) to set up the Remote Controller ID 10. SYSTEM ID Set the system id of remote controller. 11. BRIGHT, CONTRAST, COLOR, SHARPNESS Simply control brightness, contrast, color, sharpness via the remote controller. 12. INFO Display information of the picture. VCR Camera B Camera A DVR Setup Menu Configurations NO SIGNAL DISPLAY When there is no connection at the VGA and Video input, the On Screen Display will show this message. VGA Check Input Signal OSD MENU DESCRIPTION MENU SELECTION 1. Press the MENU button and then ›/‚ button to display each menu. 2. Press the ENTER or Š button and then ›/‚ button to select the menu item. 3. Press the MENU button to return to normal picture. NOTE : If you don't connect to VGA port, menu is not displayed in VGA mode. A. INPUT MENU Video A Input Source List : Video A Video B S-Video VGA Move Enter Exit -7-