Samsung WA52M7750AV/A4 User Manual - Page 47

Maintaining your washer WARNING Certain internal parts are intentionally not grounded and may present a risk electric shock only during servicing. Service personnel - Do not contact the following parts while the appliance is energized: Control board, heat sink, motor, inlet valve, heater and pump. Cleaning the exterior 1. Turn off the water faucets after finishing the day's washing. This will shut off the water supply to your washer and prevent the unlikely possibility of damage from escaping water. Leave the lid open to allow the inside of your washer to dry out. 2. Use a soft cloth to wipe up all detergent, bleach or other spills as they occur. 3. Clean the following as recommended: Control Panel - Clean with a soft, damp cloth. Do not use abrasive powders or cleaning pads. Do not spray cleaners directly on the panel. Cleaning the interior Clean the interior of your washer periodically to remove any dirt, soil, odor, mold, mildew, or bacterial residue that may remain in your washer as a result of washing clothes. Failure to follow these instructions may result in unpleasant conditions, including odors and/or permanent stains on your washer or laundry. Hard water deposits may be removed, if needed. Use cleaners labeled "Washer safe". Storing your washer Washers can be damaged if water is not removed from hoses and internal components before storage. Prepare your washer for storage as follows: 1. Select the Quick Wash cycle and add bleach to the automatic dispenser. Run your washer through the cycle without a load. 2. Turn the water faucets off and disconnect the inlet hoses. 3. Unplug your washer from the electrical outlet and leave your washer lid open to let air circulate inside the drum. If your washer has been stored in below-freezing temperatures, allow time for any leftover water in your washer to thaw out before use. Maintaining your washer WA7700M_DC68-03774D-04_EN.indd 47 English 47 2019-02-14 6:24:12