Sanyo 12KS71 Installation Instructions - Page 21
How to Test Run the Air Conditioner, Fig. 59a, Fig. 59b, Fig. 59c
View all Sanyo 12KS71 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 21 highlights
05-424 KS0971-1271 12/13/05 1:28 PM Page 21 How to Test Run the Air Conditioner After turning on power to the air conditioner, use the remote controller and follow the steps below to conduct the test run. (1) Set the remote controller in Test Run mode. (Fig. 59a) a) Press and hold the ION button. b) Then press and hold the 1HR TIMER button. c) At the same time, press the ACL (reset) button once. Use a pointed object such as the tip of a pen to press the ACL button. • After a few seconds, " " appears and "oP-1" blinks in the remote controller display area. (Fig. 59b) d) Release the 1HR TIMER button. e) Release the ION button. (2) Start Cooling mode test run by pressing the ON/OFF operation button of the remote controller. (Fig. 59a) • This starts the fan producing uncooled forced air with the 4 indicator lamps (OPERATION lamp, TIMER lamp, QUIET lamp, and ION lamp) on the main unit blinking. (Fig. 59c) • After 3 minutes, the system shifts into cooling operation, and cool air will start to be felt. Cool mode test run is unaffected by the room temperature. (3) Press the ON/OFF operation button of the remote controller again to stop the test run. (Fig. 59a) (4) Finally press the ACL (reset) button of the remote controller to release it from Test Run mode to return to normal mode. (Fig. 59a) • " " and "oP-1" will disappear from the remote controller display area. IMPORTANT After the test run is completed, be sure to press the ACL (reset) button to return to normal mode. The air conditioner will not operate correctly if this is not done. ION button ON/OFF operation button 1HR. TIMER button Ĉ Fig. 59a ACL (Reset) button Fig. 59b OPERATION lamp TIMER lamp QUIET lamp ION lamp Fig. 59c 21