Sanyo 12KS71 Installation Instructions - Page 8
Remove the Grille to Install the Indoor Unit - parts
View all Sanyo 12KS71 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
05-424 KS0971-1271 12/13/05 1:27 PM Page 8 3-4. Remove the Grille to Install the Indoor Unit Basically, these models can be installed and wired without removing the grille. If access to any internal part is needed, follow the steps as given below. CAUTION Be sure to wear work gloves during installation to avoid being cut by the sharp aluminum fins of the heat exchanger. How to remove the grille (1) Grasp both ends of the air intake grille, and remove it by opening towards the front and pulling towards you. (Fig. 16a) (2) Remove the 2 screws. (Fig. 16b) (3) Remove the screw on the right side cover plate and open the cover. (Fig. 17a) (4) Take out the thermistor from the grille. (Fig. 17b) (5) Pull the lower part of the grille toward you to remove. (Fig. 18a) (6) Use a standard screwdriver to push on the tabs to remove the grille. How to replace the grille (1) Reinstall the grille into the lower part while aligning its tabs on the upper part. (Fig. 18b) Insert the tabs in the slots and push the lower part of the grille back into position. (2) Make sure that the grille and frame are firmly fitted together by engaging the tabs. (3) Attach the thermistor on the grille. (Fig. 17a) (4) Close the cover and replace the screw. (Fig. 17a) (5) Affix the grille with the 2 previously removed screws. (Fig. 16b) (6) Install the air intake grille. (a) Allow the edge of the air intake grille to slide into the top of the indoor unit, and then insert it all the way inside. (Fig. 19a) (b) Press the bottom right and left corners of the air intake grille to attach it to the indoor unit. (Fig. 19b) NOTE Attach so that the round pins at the top right and left corners of the air intake grille are inserted into the grooves at the top right and left of the indoor unit. Air intake grille Grille Fig. 16a Screw cover Cover Thermistor Fig. 16b Fig. 17a Tab * Thermistor Fig. 17b * Grille Frame Tab Fig. 18a * * Fig. 18b Groove Pin Fig. 19b 8 Fig. 19a