Sanyo DRW500 Instruction Manual - Page 60
Troubleshooting Guide
UPC - 961613071002
View all Sanyo DRW500 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 60 highlights
TROUBLESHOOTING GUIDE If you have followed the instructions and are having difficulty operating the unit, locate the SYMPTOM in the left column below. Check the corresponding POSSIBLE CAUSE and CORRECTIVE ACTION columns to locate and remedy the problem. Power SYMPTOM No power. POSSIBLE CAUSE The power cord is not connected. The power is not on. CORRECTIVE ACTION Insert the power plug into the AC wall outlet. Press the POWER button to turn the power on. Operation SYMPTOM POSSIBLE CAUSE The operation or display is not normal. The unit must be reset. CORRECTIVE ACTION 1. Disconnect the power cord. 2. Connect the power cord again. 3. Operate the unit. Picture SYMPTOM There is no picture. The playback picture is poor. Screen size is wrong. " " appears on the TV screen. POSSIBLE CAUSE CORRECTIVE ACTION The video cable is not connected. The TV is not set to receive signals from the unit. No disc is loaded. "PROGRESSIVE" mode is set. The disc is dirty. An unplayable disc is loaded. Incorrect aspect ratio setup on TV. Incorrect "TV Display" setting. The aspect ratio of the disc is fixed on your DVD Connect the video cable into the jack. Select the correct input function on the TV. Load a disc. See page E45. Select "INTERLACE" mode. See page E44. Clean the disc or replace it. Load a playable or recordable disc. See page E38. Refer to your TV's owner manual. Select the appropriate setting for your TV screen size. See page E30. The selected function does not operate on the disc now. The feature or action cannot be completed at this time because: • The operation is prohibited by the unit or the disc. • The feature is not available at the moment. • The DVD software restricts it. • The DVD software doesn't support the feature (e.g., angles). TV picture does not appear on the TV The antenna cable is not connected. screen. TV channel is not selected. TV reception worsens after connect- RF signals are weak. ing the unit. The playback picture or TV program from the equipment connected through the unit is distorted. The program contains copy protection signals that restricts copying. See the antenna connections. See page E8. • In "NO DISC" mode, (1) press the n button, (2) press the TV button, (3) and press the CHANNEL button (+ or -) or press the number buttons on the remote control. • Press the INPUT button to select the TV mode. • Press the TV/DVD button on the remote control to select the TV mode. RF signals are being divided between the unit and the TV. Use a signal booster. Please consult your A/V dealer. Disconnect the playback equipment form the unit and connect it directly to your TV. -E59-