Sanyo ECD-T1820 Operating Instructions - Page 24

Line Out Connections

Get Sanyo ECD-T1820 PDF manuals and user guides View all Sanyo ECD-T1820 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 24 highlights

Notes • When using a two-speaker installation, the Green, Green/Black, Violet, Violet/Black wires, which are used for a four-speaker installation, are not used. The ends of these wires must be covered with electrical tape to prevent them from shorting to the unit or the vehicle chassis. • When using a two-speaker installation, set the FADER control to the center position. • When fuse replacement is necessary remove the blown fuse by using pliers. Then install the new 15 amp. fuse. Fuse 15A NG OK Burnt LINE OUT CONNECTIONS • The unit has a line output terminals. You can use a separate amplifier to upgrade your system. RCA Line-out Jacks OUTPUT REAR White L (eft) R (ight) Red External Amplifier Rear Speaker RCA Line-out Jacks (For Speakers) • Connect a patch cable (not supplied) from the White (left channel) and Red (right channel) RCA line output jacks to the line input terminals of the external amplifier. -23-

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
-23-
LINE OUT CONNECTIONS
•
The unit has a line output terminals. You can use a separate amplifier to upgrade your system.
RCA Line-out Jacks (For Speakers)
•
Connect a patch cable (not supplied) from the White (left channel) and Red (right channel) RCA line output
jacks to the line input terminals of the external amplifier.
Burnt
NG
OK
Fuse 15A
• When using a two-speaker installation, the Green, Green/Black, Violet, Violet/Black wires,
which are used for a four-speaker installation, are not used. The ends of these wires must
be covered with electrical tape to prevent them from shorting to the unit or the vehicle chassis.
•
When using a two-speaker installation, set the
FADER control to the center position.
•
When fuse replacement is necessary remove
the blown fuse by using pliers.
Then install the new 15 amp. fuse.
Notes
RCA Line-out Jacks
OUTPUT
REAR
White
L (eft)
R (ight)
Red
External
Amplifier
Rear Speaker