Sanyo HECSR1000K Service Manual - Page 12

Operation Check of Remote Controller and Sensor HEC-DR21 (TAIWAN) 1. With reclining "ERECT" and "RECLINE" on remote controller held depressed, turn ON power supply switch. 2. Red LEDs (41 places) go on for 1 second (Fig. 1). Red LEDs go on for 1 second (Fig. 1) Red's lighting-up Red's lighting-up Red's lighting-up Red's lighting-up Red's lighting-up Presses Red's lighting-up 3. Green LEDs (25 places) go on for 1 second (Fig. 2). Green LEDs go on for 1 second (Fig. 2) Green's lighting-up Green's lighting-up Green's lighting-up Green's lighting-up Green's lighting-up Green's lighting-up 4. Red LEDs at five places in the massage mode go on and operation of each sensor can be checked (Fig. 3). Operation Check of Each Sensor Body contour sensor Press in the upper part of massaging arm. Speed "FAST" LED which is lighted goes out. Perspiration sensor When a finger is placed between two electrodes, LED "Put your finger on the sensor" which is lighted goes out. Skin temperature sensor When temperature is about 17 or lower, LED "Ease" goes on. When temperature is over about 17 , LED "Ease" goes out. Pulse sensor Attach a finger to sensor by the side. LED "Recovery from fatigue" blinks. (Fig. 3) Perspiration sensor̡̙̚ Body contour sensor ̡̙̚ Skin temperature sensor̡̙̚ Skin temperature/Pulse sensor Pulse sensor ̡̙̚ Perspiration sensor electrodes Red's lighting-up - 12 -