Sanyo PLC-XD2200 RS232C Basic - Page 23

PLC-XD2200 / 2600 Basic Serial Command Specifications 7.5.Input Mode Read Command Command "CR1" [CR] Detail Get the selected Input No. Acceptable "%1" [CR] "1" = Computer 1 is selected Response %1 "2" = Computer 2 is selected "3" = Video is selected Unacceptable "?" [CR] 7.6.Lamp Time Read Command Command "CR3" [CR] Detail Get the total lamp running hours (Not actual lamp used hour, but Eco mode corresponding value). Acceptable "%1" [CR] Response %1 Shows the time period with 5 digits numbers. Example "00410"[CR] shows 410 hours Unacceptable "?" [CR] 7.7.Setting Read Command Command "CR4" [CR] Detail Get screen setting status such as Ceiling / Rear. Acceptable "%1" [CR] "11"[CR] = Normal Screen Setting "10"[CR] = Picture is top/bottom reversed. Response %1 (Status: Rear Ceiling ON) "01"[CR] = Picture is left/right reversed. (Status: Rear ON) "00"[CR] = Picture is top/bottom and left/right reversed. (Status: Ceiling ON) Unacceptable "?" [CR] 7.8.Temp Read Command Command "CR6" [CR] Detail Get the temperature data inside the projector. With some temperature sensors installed in the projector, it is possible to get all the temperature at once. Acceptable "%1_%2_%3" [CR] %1 Temperature of sensor 1 %2 Temperature of sensor 2 %3 Temperature of sensor 3 Temperature data is shown as "00.0". When the temperature goes down to -, the first character %1 becomes "-" instead of a space, like "-05.5" [CR]. Response %2 When no temperature data can be returned due to hardware %3 problems, the first character becomes "E" like"E00.0" [CR]. When several temperature sensors are equipped, Responses are returned continuously. "_31.5 _ _35.2 _ _33.4"[CR] The first data is sensor 1, then one space, and the data of sensor 2 follows. Unacceptable " "[CR] 22/23