Sanyo PLC-XP57L User Manual - Page 12

CONNECTING PROJECTOR TERMINALS OF PROJECTOR This projector has input and output terminals on its back for connecting computers and video equipment. Refer to the figures on pages 12 to 14 and connect properly. COMPUTER AUDIO INPUT 1/ AUDIO MONITOR OUTPUT JACK This terminal is switchable and can be used as Computer Audio Input 1 or Audio Monitor Output (variable). Set up the terminal as either Computer Audio Input 1 or Audio Monitor Output properly before using this terminal. (See pages 13 and 24.) COMPUTER INPUT/MONITOR OUTPUT TERMINAL (ANALOG) This terminal is switchable and can be used as Computer Input or Monitor Output. Set up the terminal as either Computer Input or Monitor Output properly before using this terminal. (See pages 13-14 and 24.) Note: This terminal outputs from the 5 BNC type computer input on INPUT 2 jacks only. COMPUTER INPUT TERMINAL (DIGITAL) Connect a computer output (Digital DVI-D type) to this terminal. The HD (HDCP Compatible) signal can also be connected. (See page 13.) COMPUTER AUDIO INPUT 2 JACK Connect an audio output (stereo) from a computer to this jack. (See page 13.) USB CONNECTOR (Series B) When controlling a computer with the remote control of this projector, connect USB terminal of your personal computer to this terminal. (See page 13.) RESET BUTTON This projector uses a micro processor to control the unit, and only occasionally, this micro processor may malfunction and need to be reset. This can be done by pressing the RESET button with a pen, which will shut down and restart the unit. Do not use the RESET function excessively. 5 BNC INPUT JACKS Connect component video output (Y, Cb, Cr or Y, Pb, Pr) from video equipment to VIDEO/Y, Cb/Pb and Cr/Pr jacks or connect computer output {5 BNC Type (Green, Blue, Red, Horiz. Sync, and Vert. Sync.)} from computer to G, B, R, H/V, and V jacks. (See pages 13 and 14.) R/C JACK When using the Wired/Wireless remote control as wired, connect the Wired remote control to this jack with a remote control cable (optional). CONTROL PORT CONNECTOR When controlling a computer with the remote control of this projector, connect the mouse port of your personal computer to this connector. (See page 13.) VIDEO INPUT JACKS Connect composite video output from video equipment to VIDEO/Y jack or connect component video outputs to VIDEO/Y, Cb/Pb and Cr/Pr jacks. (See page 14.) AUDIO INPUT JACKS Connect an audio output from video equipment to these jacks. (See page 14.) S-VIDEO INPUT JACK Connect S-VIDEO output from video equipment to this jack. (See page 14.) 12