Sanyo PLC XT20 Owners Manual - Page 57
Remote control, Display, To change the code for the projector, RC sensor
UPC - 086483065187
View all Sanyo PLC XT20 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 57 highlights
Setting Remote control The eight different remote control codes (Code 1-Code 8) are assigned to the projector; the factory-set, initial code (Code 1) and the other seven codes (Code 2 to Code 8). The same code should set on both the projector and the remote control. For example, operating the projector in "Code 7", the remote control code also must be switched to "Code 7". To change the code for the projector Select a remote control code in this Setting Menu. To change the code for the remote control: Press and hold the MENU button and a number button (1-8) on the remote control for more than five seconds to switch between the codes. (See page 17 for details.) RC sensor Select a location of the infrared remote receiver of the remote control. See "Remote Control Operating Range" on page 18 for details. Both ....... Activate both the front and back receiver. Front ...... Activate only the front receiver. Back ....... Activate only the back receiver. Display This function decides whether to display On-Screen Displays. On Show all the On-Screen displays. Use this function when you want to project images after the lamp becomes bright enough. The factory default setting is in this option. Countdown Off ........ Show the input image instead of the countdown when turning on the projector. Use this function when you want to project the image as early as possible even when the lamp is not bright enough. Off Hide the On-Screen Displays except; ●On-Screen Menu ●"Power off?" (p.26) ●"No signal" for Power management (p.58) ●"Please wait ..." ●White arrows for the True function in the Screen Menu (p.51) ●"Filter warning" icon (red) (p.74) Remote control Display Use the Point 7 8 buttons to switch between the options. 57