Sanyo R227 Owners Manual - Page 12

REMOTE CONTROL BATTERY 1. Press firmly on the battery cover and then rotate it in counter clockwise direction, the cover will come off. 2. Place the battery (CR2032) into the battery compartment according to the polarity markings, with the "+" sign facing up. 3. Place back the battery cover, press down slightly and rotate it in clockwise direction until it is firmly closed. Note: Remove the battery from the remote control if not in use for a long period of time. When the battery becomes weak, the remote control will not function properly. Replace with new battery. ** Battery Included ** BATTERY PRECAUTIONS Follow these precautions when using a battery in this device: 1. Warning -Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent type. 2. Use only the size and type of battery specified. 3. Be sure to follow the correct polarity when installing the battery as indicated in the Battery Compartment. A reversed battery may cause damage to the device. 4. If the device is not to be used for a long period of time, remove the battery to prevent damage or injury from possible battery leakage. 5. Do not try to recharge a battery not intended to be recharged; it can overheat and rupture. (Follow battery manufacturer's directions.) 6. Battery shall not be exposed to excessive heat such as sunshine, fire or the like. Configure Menu Choosing the option you want from the Configure menu 1. Press the SELECT button. (Note: if you make a mistake at any point, press the BACK button to go back to the previous screen.) 2. Turn the knob until 'Configure' is displayed 3. Press the SELECT button. 4. Turn the knob until the display shows the option you want. 5. Press the SELECT button to choose the option shown on the display. The options are explained below. Enables you to scan again for connection to another wireless network, or to manually configure the network parameters. Use this if you take the Internet radio to another building where you want to use it. Displays the version numbers of the various parts of software on your Internet radio. US-10