Sanyo XP56 Instruction Manual, PLC-XP56 - Page 44
Caution - plc bulb
View all Sanyo XP56 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 44 highlights
APPENDIX LAMP REPLACEMENT LAMP REPLACE When the life of the Projection Lamp of this projector draws to an end, the LAMP REPLACE indicator lights yellow. If this indicator lights yellow, replace the projection lamp with a new one promptly. TOP CONTROL This indicator lights yellow when the life of the projection lamp draws to an end. Replace the Projection Lamp with a new one promptly. Allow a projector to cool, for at least 45 minutes before you open Lamp Cover. The inside of a projector can become very hot. CAUTION For continued safety, replace with a lamp assembly of the same type. Do not drop a lamp assembly or touch a glass bulb! The glass can shatter and may cause injury. Follow these steps to replace lamp assembly. 1 Turn off a projector and disconnect AC plug. Allow a projector to cool for at least 45 minutes. 2 Loosen 2 screws with a screwdriver and open Lamp Cover. 3 Loosen 2 screws with a screwdriver and pull out Lamp Assembly by grasping Handle. 4 Replace Lamp Assembly with a new one and tighten 2 screws back. Make sure that Lamp Assembly is set properly. Replace Lamp Cover and tighten 2 screws. 5 Connect AC Power Cord to a projector and turn it on. 6 Reset Lamp Replace Counter (refer to next page "Lamp Replace Counter" section). NOTE : Do not reset Lamp Replace Counter when Projection Lamp is not replaced. LAMP ASSEMBLY LAMP COVER HANDLE ORDER REPLACEMENT LAMP Replacement Lamp can be ordered through your dealer. When ordering a Projection Lamp, give the following information to the dealer. G Model No. of your projector : G Replacement Lamp Type No. : G Replacement Lamp Type No. : PLC-XP55/XP55L/XP56/XP56L POA-LMP67 (for PLC-XP55/XP55L) (Service Parts No. 610 306 5977) POA-LMP81 (for PLC-XP56/XP56L) (Service Parts No. 610 314 9127) 44