Sanyo XP56 Instruction Manual, PLC-XP56 - Page 48
Projector Condition, Indicators
View all Sanyo XP56 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 48 highlights
APPENDIX INDICATORS AND PROJECTOR CONDITION Check the Indicators for projector condition. Indicators LAMP WARNING REPLACE TEMP. yellow red READY green LAMP red Projector Condition The projector is OFF. (The AC Power Cord is unplugged.) ✽ The projector is READY to be turned on with the POWER ONOFF button. ✽ The projector is operating normally. The Warning Temp. Indicator flashes red to let you know the internal temperature of the projector exceeds the normal level. If the temperature goes up further, the projector will be turned off ✽ automatically and the Ready indicator will go out. When the projector is cooled down enough and the temperature returns to nor- mal, the READY indicator lights green and the projector can be turned on. (The WARNING TEMP. indicator keeps flashing.) Check and clean the Air Filter. The projector is cooled down enough and the temperature ✽ returns to normal. When turning on the projector, the WARNING TEMP. indicator stops flashing. Check and clean the Air Filter. ✽ The projector is being cooled down. It cannot be turned on until the READY indicator lights green. The projector detects an abnormal condition and cannot be turned on. Unplug the AC Power Cord and plug it again to turn ✽ on the projector. If the projector is turned off again, disconnect the AC Power Cord and contact the dealer or the service center for service and checkup. Do not leave the projector on. It may cause electric shock or a fire hazard. ✽ The projector is in the Power management mode. • • • on • • • flashing • • • dim • • • off ✽ When the life of the projection lamp draws to an end, the LAMP REPLACE indicator lights yellow. When this indicator lights yellow, replace the projection lamp with a new one promptly. Reset the Lamp Replace Counter after replacement of the lamp. 48