Schwinn 206 Recumbent Bike Owner's Manual - Page 14

OPERATION Setting Goals: Once you select an exercise program, you can set "goals" for TIME, DISTANCE, or CALORIES. For example, if you set a CALORIE goal of 100, once you start the program, you will notice that the CALORIE display will count down from 100 to 0. If you do not want to set a goal in any of the above, simply press ENTER to advance to the next goal choice or press START / STOP to begin exercising. When the TIME, DISTANCE, or CALORIES display is flashing, enter values by using the UP or DOWN button to select a value then press ENTER to confirm the value and advance to the next goal choice. When a goal is reached during your exercise, the corresponding display will flash and the computer will beep, signaling that your workout is complete. We recommend that you only set one goal (TIME, DISTANCE, or CALORIES) for each exercise. Note, if no goals are set and the goal displays are 0, the TIME, DISTANCE, and CALORIES values will count up once the START / STOP button is pressed and you begin exercising. Quick Start: If you want to immediately start exercising without choosing any specific program or inputting any goals, simply press the START / STOP button after the computer powers up to begin exercising in the Manual mode. Resistance control: In the MANUAL program you can adjust the level of resistance at any time by using the UP or DOWN buttons to select from level 1 to level 8. In the preset profile programs you can also adjust the level of resistance, but you can not lower the resistance below the minimum preset resistance. For example if the minimum preset level of resistance in one interval of the preset profile program is level 2, you are not able to manually lower the resistance to level 1. However, you can raise and lower the resistance between the lower and upper presets. Exercising with preset TIME: The workouts are segmented into 16 intervals. If you preset the TIME, each segment of your workout is 1/16 of the total TIME you entered. For example if you enter a workout TIME of 16 minutes, each segment (interval) is 1 minute in duration. The TIME counts down from the preset TIME you entered until the program reaches 0, the display flashes, and the program ends. Exercising without preset TIME: If you choose not to preset TIME you can enter a preset DISTANCE. To do this make sure that the TIME is set to 0:00 and press ENTER when the TIME display is flashing to advance to DISTANCE. When setting a preset DISTANCE each segment (interval) counts down in units of .01 until the program reaches 0, the display flashes, and the program ends. If you choose not to enter a preset distance the program advances (counts up) in increments of .01 until you choose to stop exercising. To advance to set a CALORIE goal do not preset a TIME or a DISTANCE goal (make sure those values are set to 0). Just press ENTER when those displays flash. This will bring you to the CALORIE goal. 12