Seagate ST9146853SS Savvio 15K.1 SAS Product Manual - Page 67
Jitter tolerance masks
View all Seagate ST9146853SS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 67 highlights
9.5.2.1.3 Jitter tolerance masks Figure 17 describes the receive tolerance eye masks and is constructed using the X2 and Z2 values given in table 19. X1OP is half the value for total jitter intable 19 and X1TOL is half the value for total jitter in table 20, for jitter frequencies above ((bit rate) / 1.667). Absolute amplitude (in V) (additional sinusoidal jitter) / 2 Z2 Z1OP Z1TOL 0 V -Z1TOL -Z1OP -Z2 0 X1OP X2 1 1-X1OP X1TOL 1-X1TOL Normalized time (in UI) Outline of eye mask before adding sinusoidal jitter Outline of eye mask after adding sinusoidal jitter Figure 17. Reveive tolerance eye mask The leading and trailing edge slopes of figure 16 shall be preserved. As a result the amplitude value of Z1 is less than that given in table 18 and Z1TOL and Z1OP shall be defined from those slopes by the following equation: where: Z1TOL = Z1OPx -X----2---O-----P 0----,---5----)--x---a----d---d---i--t-i--o---n---a----l---s---i-n---u----s---o---i-d----a---l---j-i--t-t--e---r X----1----O-----P-X2OP - X1OP Z1TOL is the value for Z1 to be used for the tolerance masks; and Z1OP, X1OP, and X2OP are the values in table 18 for Z1, X1, and X2. The X1 points in the receive tolerance masks are greater than the X1 points in the receive masks, due to the addition of sinusoidal jitter. Savvio 15K SAS Product Manual, Rev. C 61