Sennheiser ew 300 IEM G2 Instructions for Use - Page 62
Changing the transmission power SR 350 IEM G2 only
View all Sennheiser ew 300 IEM G2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 62 highlights
̈ Connect the two BNC connectors to the BNC sockets ƺ on the twin transmitter. ̈ Slide the twin transmitter into the 19'' rack. ̈ Resecure the rack mount "ears" ³ to the rack ³. ̈ Connect the telescopic antennas to the BNC sockets . ̈ Pull the end caps to extend the telescopic antennas . Changing the transmission power (SR 350 IEM G2 only) With the SR 350 IEM G2 twin transmitter, you can choose between two different transmission powers. ATTENTION! Danger of interference with other transmitters! Depending on the selected transmission power and frequency, you may have to apply for an approval from the respective authority for a radio transmission licence, as you could interfere with other transmitters. This approval will only be valid for the approved transmission power. For detailed information, please refer to the enclosed frequency data sheets and to the countryspecific frequency and transmission power overviews. ̈ Apply for an approval, should country-specific regulations on frequency and/or transmission power usage require this. ATTENTION! Danger of damage to the device! Due to the high transmission power (100 mW) in the switch position "STANDARD", the optional AC 2 transmitter combiner must not be used as this can cause damage to the devices. ̈ Use only the optional AC 3200 transmitter combiner (see "Accessories and spare parts" on page 40). ̈ Set the transmission power switch (RF POWER) ƻ to the desired position. Transmission power will change as follows: Switch position Transmission power LOW 15 mW ƻ STANDARD 100 mW 15