Sennheiser ew 300 IEM G2 Instructions for Use - Page 76
Multi-channel operation, Adjusting the squelch threshold receiver only - user manual
View all Sennheiser ew 300 IEM G2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 76 highlights
SQELCH Ƹ ̈ Select "START" and confirm your selection by pressing the SET button. After the scan is completed, the number of free channels is displayed. Pressing the SET button once more will store the scan result and lock all channels that are used or subject to interference. Releasing locked channels ̈ Select the "SCAN" menu. ̈ Select "CLEAR" and confirm your selection by pressing the SET button. All channels in this channel bank can now be selected again. Multi-channel operation For multi-channel operation, only use the free channels in a channel bank. Before putting the transmission links into operation, we recommend performing an auto scan. ̈ Select a channel bank on a receiver. ̈ Scan this channel bank for free channels. If not enough free channels are available in the selected channel bank, repeat the scan with another channel bank. ̈ Apply the scan result to all other transmitters and receivers. Note: If you have the SR 350 IEM G2 twin transmitter connected to the NET 1 network system, follow the instructions of the user manual of the NET 1. Adjusting the squelch threshold (receiver only) The receiver is equipped with a squelch that can be adjusted via the "SQELCH" menu. The squelch eliminates annoying noise when the transmitter is switched off. It also suppresses sudden noise when there is no longer sufficient transmitter power received by the receiver. Note: Before adjusting the squelch threshold to a different setting, use the volume control Ƹ to set the volume for the connected headphones to the minimum. There are three possible squelch settings: y LO = low y MID = middle y HI = high Selecting the setting "LO" reduces the squelch threshold, selecting the setting "HI" increases the squelch threshold. Adjust the squelch threshold - with the transmitter switched off - to the lowest possible setting that suppresses hissing noise. Notes: y If the squelch threshold is adjusted too high, the transmission range will be reduced. Therefore, always adjust the squelch threshold to the lowest possible setting. y When in the setting mode of the "SQELCH" menu, pressing the ̄ button for more than three seconds will switch the squelch off. "SQ.OFF" appears on the display. If no RF signal is being received, hissing noise will occur. This setting is for test purposes only. 29