Sennheiser ew 300 iem Instructions for Use - Page 37
mm jack plug
View all Sennheiser ew 300 iem manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 37 highlights
ᕨᕩ µ ¸ Connecting the pre-amplifier/mixing console Ǡ Connect the outputs from the pre-amplifier/mixing console/etc. to the 1/4" (6.3 mm) jack sockets µ (left or MONO) and ¸ (right). Both balanced and unbalanced connection is possible. Note: Any device that is only suitable for mono operation must be connected to jack socket µ. In this case, the stereo operation must be switched off via the menu. 1/ " (6.3 mm) jack plug 4 balanced unbalanced Switching the transmitter on/off Ǡ Press the POWER button ᕧ to switch the transmitter on. Ǡ To switch the transmitter off, press the POWER button until "OFF" appears on the display. You can then release the button. After a power failure, the device returns to the previous setting (ON/OFF). ᕧ ᕡᕢ Connecting the headphones/monitoring the audio signal Ǡ Connect the headphones to the headphone output (PHONES) ᕡ for monitoring the audio signal. Only connect headphones with a 1/4" (6.3 mm) stereo jack plug. Ǡ Use the headphone volume control ᕢ to adjust the volume. Attention: First set the volume control to the lowest volume by turning it to the left as far as possible! 1/ " (6.3 mm) stereo jack plug 4 for headphone connection Volume up? - NO! When people use headphones, they tend to choose a higher volume than with loudspeakers. Listening at high volume levels for long periods can lead to permanent hearing defects. Please protect your hearing, Sennheiser headphones have an excellent sound quality even at low volumes. 39