Sharp 32NS350 32NS350 Operation Manual - Page 39
Tv-catv, Display, Ch Down, Remote Keypad, Ch Up
View all Sharp 32NS350 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 39 highlights
Operation of Remote Control (Continued) (1) Slide TV-CATV switch to CATV. (2) Press and hold down DISPLAY and CH DOWN (9) on your remote control. Then release both buttons. (3) Within ten seconds after releasing DISPLAY and CH DOWN (9), enter your converter's twodigit code number using REMOTE KEYPAD (refer to list). • The remote control is now ready to send commands to your converter. • Some brands have more than one remote code listed due to changes in the remote codes from early to later model years. In such cases, you may have to try more than one code to find the code your converter accepts. NOTE: Depending on the model, year produced, brand, and type of CATV converter, some models may not be compatible with the remote control. L To Identify Your Cable Converter - Search Method. (1) Slide TV-CATV switch on the remote to CATV. (2) Press the POWER button on the cable converter to ON. (3) Stand at least six feet away from the converter. Point the remote towards the converter. Hold down the DISPLAY and CH UP (8) at the same time. KEEP HOLDING THE BUTTONS DOWN. (4) Watch the Channel Number indicator on the converter. Channel numbers will scan up when the converter has been identified. Release the DISPLAY and CH UP (8) as soon as the channel numbers start to scan up. The converter's remote control code number has been identified, and the remote is ready to operate the converter. TIPS ON IDENTIFYING YOUR CABLE CONVERTER: Be Patient: a minute or two can seem a lot longer when you're waiting for something to happen, but the code should be identified within two minutes. Remember, it is only a one-time set-up. Be careful not to let the CATV converter scan more than five channels when the indicator starts to move up. If you continue holding down the DISPLAY and CH UP (8) after five channel scans, the proper remote code can be passed up, and the two minute identify cycle will have to be repeated. If a channel change does not occur on the cable converter within two minutes, read the identifying instructions again and repeat the steps. Should a channel change still not occur, the remote will not operate with the desired converter. CATV CONVERTER REMOTE CONTROL BRAND CODE NUMBER Anvision Cable Star Eagle Eastern International __ General Instrument ____ Hamlin Jerrold Macom Magnavox ___________ NSC Oak Oak Sigma __________ Panasonic Philips Pioneer Randtek RCA Regal Regency Scientific Atlantic ______ Sony Sylvania Teknika Texscan Tocom Unika Viewstar Zenith 07, 08 07, 08 08 02 04, 05, 15, 23, 24, 25, 30, 36 12, 13, 34 04, 05, 15, 23, 24, 25, 30, 36 37 07, 08, 19, 25, 28, 29, 32, 33, 40, 41 09 01, 16, 38 18 27, 39 07, 08, 19, 26, 28, 29, 32, 33, 40, 41 18, 20 07, 08 27, 43 12, 13 02 03, 22, 42 44 11 06 11 17, 21 31 07, 08, 19, 26, 28, 29, 32, 33, 40, 41 14 NOTE: Some satellite receivers can be operated by the REMOTE CONTROL. If you have a Satellite Receiver, you can use the above method to search for available channels. 39 32-48 32N-S350 39 5/25/00, 1:16 PM