Sharp AL-1200 AL1200 Operation Manual - Page 16
Power To Copier
View all Sharp AL-1200 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 16 highlights
LOADING COPY PAPER 6 Gently push the paper tray back into the copier. After loading copy paper, to cancel the blinking "P" without restarting copying, press the clear ( ) key. The "P" in the display will go out and the ready ( ) indicator will light up. 2 Installation POWER TO COPIER 1 Ensure that the power switch of the copier is in the OFF position. Insert the attached power cord into the power cord socket at the rear of the copier. If you use the copier in a country other than the country where the copier was purchased, you will need to make sure that your local power supply is compatible with your model. If you plug the copier into an incompatible power supply, irreparable damage to the copier will result. 2 Plug the other end of the power cord into the nearest outlet. Only insert the power cord into a properly grounded wall socket. Do not use extension cords or power strips. 15