Sharp AL1215 AL1215|AL1530|AL1540|AL1551 Operation Manual - Page 49

Do not insert paper in the single bypass when a copy job from the paper tray is in progress. This will cause a misfeed. • If you start a print job while a copy job is in progress, the print job will begin when the copy job is completed. • The scanning function cannot be used while a copy job is in progress. About interrupt copying If you press the start ( ) key to begin a copy job while a print job using the paper tray or multi-bypass tray is in progress, the copy job will begin automatically after the print data in the unit's memory is printed (interrupt copying). When this is done, the print data remaining in the computer is not sent to the unit. When the copy job ends, press the clear ( ) key twice, or press the ON LINE key once to change the unit to the online state (p.31), or wait until the set auto clear time (p.55) elapses. The remaining print data will be sent to the unit and printing will resume. Interrupt copying is not possible during a print job using the single bypass. ORIGINAL PLACEMENT Using the original table • The original table can read up to 8-1/2" x 14" original. 5 • Image loss 5/32" (4mm) can occur at the leading and trailing edges of the copies. Also image loss 11/64" (4.5mm) in total can occur along the other edges of the copies. • When copying a book or an original which has been folded or a crumpled original, press down the original cover lightly. If the original cover is not securely closed, the copies may be striped or blurred. 1 Open the original cover/SPF/RSPF, and place the original. 2 Place an original face down on the original table. Align it with the original scale and the centering ( ) mark. Gently close the original cover/SPF/RSPF. Original scale mark 47