Sharp AL1215 AL1215|AL1530|AL1540|AL1551 Operation Manual - Page 50
Using the SPF/RSPF
![]() |
UPC - 074000074477
View all Sharp AL1215 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 50 highlights
Using the SPF/RSPF The SPF/RSPF is designed to hold up to 30 originals measuring from 5-1/2" x 8-1/2" to 8-1/2" x 14" and weighting from 14 lbs. to 23.9 lbs. (52g/m2 to 90g/m2). • Before feeding originals in the original feeder tray, be sure to remove any staples or paper clips from them. • Before placing curled or wavy originals into the original feeder tray, be sure to flatten them. If not, original misfeeds may result. • The SPF/RSPF ( ) indicator on the operation panel will light up. If this indicator does not light up, the originals are not properly set or the SPF/RSPF is not properly closed. • Badly damaged originals may misfeed in the SPF/RSPF. It is recommended that such originals be copied from the original table. • Special originals such as transparency film should not be fed through the SPF/RSPF, but should be placed directly on the original table. • Image loss (max. 5/32" (4mm)) can occur at the leading and trailing edges of the copies. Also image loss (max. 11/64" (4.5mm) in total) can occur along the other edges of the copies. It can be 15/64" (6mm) (max.) at the trailing edge of the second copy of two-sided copying. • To stop continuous copying using the SPF/RSPF, press the clear ( ) key. • Copying using one-sided to one-sided mode (AL-1551CS): Ensure that no indicator is lit among the original to copy indicators. 1 Make sure that no original is left on the original table. 2 Adjust the original guides to the size of originals. 3 Set the originals face up in the original feeder tray. Original face up Stream feeding mode The stream feeding mode allows easy operation of continuous copying from the SPF/RSPF. If the stream feeding mode has been enabled using user program No.4, the SPF/RSPF ( ) indicator will blink approximately 5 seconds after the last original has been fed by the SPF/RSPF. While this indicator is blinking, any new originals placed in the original feeder tray will be fed and copied automatically. If the stream feeding mode has been disabled, the start ( ) key must be pressed each time the originals are set even immediately after completion of a copy run from the SPF/RSPF. The default setting of the stream feeding mode is "ON". See "USER PROGRAMS" (p.55). 48
![](/manual_guide/products/sharp-al1215-al1215al1530al1540al1551-operation-manual-abf31e5/50.png)