Sharp AR-M208 AR-M208 Key Operator's Guide - Page 18
Disable Auto Power Shut-off, Disable Beep at Key Touch, Disable Backlight Change - toner for n
View all Sharp AR-M208 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 18 highlights
KEY OPERATOR PROGRAMS Disable Auto Power Shut-off The auto power shut-off mode is used to turn off the power to the fuser automatically once a programmed length of time has elapsed without any copier operation after the last copy of a run is made or power is turned on. This mode lowers the user's electricity bill, reduces waste of natural resources, and cuts down on environmental pollution. Depending on how the machine is to be used, you may wish for some reasons to disable this mode. This can be done using this program. NOTE: Since we would like you to fully understand the purpose of this mode, we suggest that you enable this mode and set the most appropriate time using program "AUTO POWER OFF" (page 13). To disable the auto power shut-off mode, highlight "DISABLE AUTO POWER SHUT-OFF" and press the OK key to display a check mark in the check box. To restore the mode, select this program and press the OK key again to clear the check mark in the check box. Disable Beep at Key Touch This program is used to enable or disable the beep function. If this function is enabled, a beep sound will be produced when you press a key on the operation panel. To disable the beep function, highlight "DISABLE BEEP AT KEY TOUCH" and press the OK key to display a check mark in the check box. To enable the beep function, select this program and press the OK key again to clear the check mark in the check box. Disable Backlight Change If backlight color change is enabled, the color of the backlighting of the display varies with the copier status as shown below: Green: Normal Yellow: Toner is low or maintenance will be needed soon Orange: The copier cannot operate because of a misfeed, no toner or some other malfunction. This program is used to disable the function that changes backlighting color. (Backlight color change is disabled in the factory default setting.) To disable change of the backlight color, highlight "DISABLE BACKLIGHT CHANGE" and press the OK key to display a check mark in the check box. To enable the function, select this program and press the OK key again to clear the check mark in the check box. 16