Sharp CD-SW440N CD-SW440N Operation Manual - Page 11

Listening to a cassette tape Note: Tape recording function is not available in this unit. Before playback: ● For playback, use normal or low-noise tapes for the best sound. (Metal or CrO2 tapes are not recommended.) ● Do not use C-120 tapes or poor-quality tapes, as they may cause malfunctions. ● Before loading a tape into the cassette compartment, tighten the slack with a pen or a pencil. POWER ON/STAND-BY MINI COMPONENT SYSTEM CD-SW440 POWER ON/STAND-BY FUNCTION VOL PUSH OPEN Various tape functions Function Tape playback Main unit Remote control Operation Press in the stop mode. Stop Fast ____ forward/ Fast rewind Press in the playback, fast forward or fast rewind mode. Press in the playback or stop mode. Caution: ● To remove the cassette, press the (TAPE ) button, and then open the compartment. ● If a power failure occurs during tape operation, the tape head will remain engaged with the tape and the cassette door will not open. In this case, wait until the power is restored. CD USB TAPE TAPE Tape playback 1 Press the ON/STAND-BY button to turn the power on. 2 Press the FUNCTION button on main unit repeatedly or TAPE button on remote control to select TAPE function. 3 Open the cassette door VOL VOL by pushing the area AUDIO IN marked " PUSH OPEN". PHONES POUPSEHN 4 Load a cassette into the cassette compartment. PUSH OPEN M I N I C O M PCOD-NSWE44N0T S Y S T E M ONP/SOTWANEDR-BY FUNCTION VOL OPEN/ CLOSE AUDIO IN PHONES 5 Press the / (TAPE ) button to start playback. E-10