Sharp CD-SW440N CD-SW440N Operation Manual - Page 5

Listening to the iPod Supported iPod models: ● iPod nano (software 1.2 above) ● iPod mini (software 1.2 above) ● iPod (5th generation) (software 1.3 above) (Dock connector equipped Click Wheel model) ● iPod (4th generation) (software 3.0.2 above) (Dock connector equipped Click Wheel model) ● iPod nano (2nd generation) (software 1.0.0 above) ● iPod nano (3rd generation) (software 1.0.3 above) ● iPod nano (4th generation) (software 1.0.3 above) ● iPod classic (software 1.0.3 above) ● iPod touch (software 1.1 above) ● iPod touch (2nd generation) (software 2.1 above) Caution: Please update your iPod unit to the latest software version from Apple's homepage before using it. iPod adaptor connection Notes: ● iPhone is not supported by this system. ● You can use an audio cable to connect your iPod to the AUDIO IN jack if: 1. your iPod adaptor does not fit into the iPod dock on the main unit. 2. you have an iPod that does not have an iPod adaptor. 3. you have an iPod that does not have an iPod 30 pin connector. To insert iPod adaptor 1 Press the ON/STAND-BY button to turn the power on. 2 Insert the iPod adaptor into the iPod dock and connect your iPod. iPod (bottom) iPod POWER ON/STAND-BY MINI COMPONENT SYSTEM CD-SW440 POWER ON/STAND-BY FUNCTION VOL CD USB TAPE To remove iPod adaptor Insert the tip of a screwdriver ("-" type, small) into the iPod adaptor hole as shown and lift upward to remove. Dock connector iPod adaptor (not supplied) iPod dock iPod connector iPod playback 1 Press the ON/STAND-BY button to turn the power on. 2 Press the iPod button on the remote control or FUNCTION button repeatedly on the main unit to select iPod function. 3 Insert iPod unit in iPod dock of main unit. 4 Press the / button to start playback. Notes: ● Once the iPod is connected to the unit it will begin charging. ● The iPod unit cannot be charged while the main unit is in the stand- by mode or during USB mode. ● Please make sure to set iPod unit to either NTSC or PAL to match your TV signal. Please visit Apple's homepage for further information. To disconnect iPod Simply remove the iPod from the iPod dock. It is safe to do so even during playback. Navigating the iPod menus 1 Press the MENU button to view the menu on iPod unit. Press it again to go back to previous menu. 2 Use the TUNING ( or ) button on the remote control to select an item on the menu and then press ENTER button. Note: When navigating the iPod menus with remote control, do not operate any of the buttons on the iPod unit. The volume level is adjusted by pressing the VOL (+ or -) button on the main unit or the remote control. Adjusting the volume on the iPod unit gives no effect. iPod operation: The operations described below depend on the generation iPod you are using. System on operation: When the main unit is powered on, the iPod unit will automatically power on when docked in the unit (including TIMER function/exclude USB function). System off (stand-by operation): When the main unit is turned to stand-by mode, the docked iPod unit will automatically turn to stand-by mode. E-4