Sharp CD-SW440N CD-SW440N Operation Manual - Page 7

Listening to a CD or MP3/WMA disc (continued) Direct track search By using the Direct Search buttons, the desired tracks on the current disc can be played. Use the Direct Search buttons on the remote control to select the desired track while playing the selected disc. ● The Direct Search buttons allow you to select up to number 9. ● When selecting number 10 or higher, use the "10+" button. A. For example, to choose 13 1 Press the "10+" button once. 2 Press the "1" button. 3 Press the "3" button. Selected track number B. For example, to choose 130 1 Press the "10+" button twice. 2 Press the "1" button. 3 Press the "3" button. 4 Press the "0" button. Notes: ● A track number higher than the number of tracks on the disc cannot be selected. ● During random play, direct search is not possible. To stop playback: Press the (CD ) button. Repeat play Repeat play can play one track, all tracks or a programmed sequence continuously. To repeat one track: Press the PLAY MODE button repeatedly until "1REPEAT" appears. Press the / (CD / ) button. To repeat all tracks: Press the PLAY MODE button repeatedly until "ALL REPEAT" appears. Press the / (CD / ) button. To repeat desired tracks: Perform steps 1 - 5 in "Programmed play" section on pages 6 - 7 and then press the PLAY MODE button repeatedly until "ALL REPEAT" appears. To cancel repeat play: Press the PLAY MODE button repeatedly until "NORMAL" appears and " " disappears. Random play The tracks on the disc can be played in random order automatically. To random play all tracks: Press and hold down PLAY MODE button on the remote control until "RANDOM" appears. Press the / (CD / ) button. To cancel random play: Press and hold the PLAY MODE button until "NORMAL" appears and "R" disappears. Notes: ● If you press the button during random play, you can move to the track selected next by the random operation. On the other hand, the button does not allow you to move to the previous track. The beginning of the track being played will be located. ● In random play, the unit will select and play tracks automatically. (You cannot select the order of the tracks.) Caution: After performing repeat play, be sure to press the (CD ) button. Otherwise, the disc will play continuously. Programmed play (CD) 1 While in the stop mode, press the MEMORY button on the remote control to enter the programing save mode. 2 Press the or buttons on the remote control to select the desired track. Selected track number 3 Press the MEMORY button to save the track number. 4 Repeat steps 2 - 3 for other tracks. Up to 32 tracks can be programmed. If you want to check the programmed tracks, press the MEMORY button repeatedly. If you make a mistake, the programmed tracks can be cleared by pressing the CLEAR/DIMMER button. 5 Press the / (CD / ) button to start playback. E-6