Sharp DV-SR45U Operation Manual - Page 10
DISPLAY menu, Using a remote control, Installing batteries in the remote control - dvd recorder manual
UPC - 074000354449
View all Sharp DV-SR45U manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
Before you start Functional overview (cont'd) Installing batteries in the remote control Using a remote control Install two "AA" size batteries (supplied) matching the polarity indicated inside battery compartment of the remote control. 1 2 3 Note: Incorrect use of batteries can result in hazards such as leakage and bursting. Please observe the following: • Do not mix new and old batteries together. • Do not use different kinds of batteries together, although they may look similar, different batteries may have different voltages. • Make sure that the plus and minus ends of each battery match the indications in the battery compartment. • Remove batteries from equipment that is not going to be used for a month or more. • When disposing of used batteries, please comply with governmental regulations or environmental public instruction's rules that apply in your country or area. • Do not recharge, short-circuit, heat, burn or disassemble batteries. Keep in mind the following when using the remote control: • Make sure that there is no obstacle between the remote control and the remote sensor on the DVD recorder. • Use within the operating range and angle as shown. • Remote operation may become unreliable if strong sunlight or fluorescent light is shining on the remote sensor of the DVD recorder. • Remote control for different devices can interfere with each other. Avoid using remote control for other equipment located close to the DVD recorder. • Replace the batteries when you notice a fall off in the operating range of the remote control. Within about 23feet (7m) 60˚ POWER Remote REV controlP OTROIGPINMAELNU/ ENTER REC REC PLAY MONRITEOCR SPEED CLEAR PAUSE CH 7 PQRS 4 0SPACE SKIP DISPLAY 1 .@/: GHI 8 TUV 5 JKL 2 CM 9 SKIP WXYZ ABC 6 MNO PRTOIMGE. R 3 DEF STOP FWD PLAYMLEINSUT OPEN/CLOSE Guide to Displays on screen menu This unit uses the following on screen menu for most operations: SETUP/DISC/CD menu,Title list, and DISPLAY menu.They allow you to change the playing status of disc during play. The DISPLAY menu also gives you information on the status of the disc. DISPLAY menu Press DISPLAY button to call up the display menu.This menu will give you the information on the playing disc. Some operations are available while disc is playing. Details are on page 41. 3 1 1 1 4 00:00:00 DVD-RW Video mode SP 1:25 Rem. 2 1. Indicates a disc type and a format mode. NOTE: In some descriptions on this manual, only one disc type is indicated as an example. 2. Indicates a recording mode and possible recording time. 3. Indicates a title number, chapter number, and the time lapse of disc play. 4. Each icon means: : Search : Audio : Subtitle : Angle (except VR mode) : Repeat : Marker : Noise Reduction : Zoom 10