Sharp DV-SR45U Operation Manual - Page 35

Recording Timer recording (cont'd) Before you start Connections Getting started Recording Playing discs 8 Select the channel number to record using K / L buttons, then press B button. Setup > Recording > Timer Programming Date Start 1. JAN/12 10:00PM 2. - - - End CH Speed 10:30PM CH8 To record from external input, L1 or L2. 9 Select a recording speed using K / L buttons. 10 11 Press ENTER button when all information required is entered. Your program setting will be stored. • To set another program, repeat steps 5 to 10. • To exit, press SETUP button. 11 Press POWER button to turn off. indicator will appear on the front display. POWER DISPLAY OPEN/CLOSE TIMER PROG. A .@/: 1 CH REC MONITOR GHI 4 PQRS 7 REC MODE CLEAR REC PAUSE F ABC DEF 2 3 JKL 5 TUV 8 SPACE 0 MNO 6 WXYZ 9 CM SKIP SKIP H G B PLAY REV FWD h g STOP C SETUP TOP MENU MENU/LIST K REPEAT ENTER { B ZOOM RETURN L 8 9 Setup > Recording > Timer Programming Date Start 1. JAN/12 10:00PM 2. - - - End CH Speed 10:30PM CH8 XP Refer to "Recording speed" on page 26. Checking, canceling, or correcting the timer programming information 10 Note • After step 11, the DVD recorder will be turned on automatically 2 minutes in advance of the recording time to start and waits to start. Then the recording will start at the recording time you set. 1 Press POWER button so that indicator disappears from the front display. 2 Press TIMER PROG. button. Timer Programming list will appear. Setup > Recording > Timer Programming Date Start 1. JAN/12 10:00PM 2. - - - End CH Speed 10:30PM CH8 XP 3 Check the information on the list you will need. 4 To clear the timer programming, select your desired program using K / L buttons.Then, CLEAR button. To correct the timer programming, select your desired program using K / L buttons.Then, press ENTER button. Next, correct the timer programming by using press K/L/{/B buttons. Finally, press ENTER button again. 5 Press TIMER PROG. button to exit. 6 Press POWER button to return to the timer standby mode. To stop the timer recording in process Press C (STOP) button on the front panel of the main unit. STOP C button on the remote control is not effective. 1 6 4 POWER DISPLAY OPEN/CLOSE TIMER PROG. A .@/: 1 CH REC MONITOR GHI 4 PQRS 7 REC MODE CLEAR REC PAUSE F ABC 2 JKL 5 TUV 8 SPACE 0 DEF 3 MNO 6 WXYZ 9 CM SKIP SKIP H G B PLAY REV h STOP C SETUP TOP MENU K FWD g MENU/LIST REPEAT ENTER { B ZOOM RETURN L 2 5 4 Note • Press TIMER PROG. button to check the timer programming in process. When the timer recording is proceeding, that program will be highlighted with red. In this case, you cannot select any other program. 35 Editing Changing the SETUP menu Others Español