Sharp DV-SR45U Operation Manual - Page 8

Before you start Functional overview Front Panel 1 2 3 4 5* 6* 7* 8 9 (*) The unit can also be turned on by pressing these buttons. REC/OTR OPEN/CLOSE 15 14 13 12 11 1. POWER button Press to turn the DVD recorder on and off. If timer programmings have been set, press to set the unit in timer-standby mode. 2. CH L / K button Press to change the channel up and down. 3. E (REV) button During playback, press to skip to the previous chapter or track. During playback, press and hold for 1.5 seconds to fast reverse. When playback is paused, press repeatedly to slow reverse. 4. D (FWD) button During playback, press to skip to the next chapter or track. During playback, press and hold for 1.5 seconds to fast forward. When playback is paused, press repeatedly to slow forward. 5. C (STOP) button* Press to stop play or recording. 6. B (PLAY) button* Press to start or resume play. 7. OPEN/CLOSE A button* Press to open or close the disc tray. Rear Panel 1 10 8. Disc tray Place a disc when open. 9. Display Refer to "Front Panel Display Guide" on page 12. 10. Remote control sensor Receive signals from your remote control so that you can control the DVD recorder from a distance. 11. REC/OTR button Press once to start a recording. Press repeatedly to start a one-touch timer recording. 12. REC MODE button Press to switch the recording speed. 13. AUDIO INPUT jacks (LINE2) Use to connect external equipment with standard audio cables. 14. VIDEO INPUT jack (LINE2) Use to connect external equipment with a standard video cable. 15. S-VIDEO INPUT jack (LINE2) Use to connect the S-Video output of external equipment with an S-Video cable. 2 34 5 6 R DIGITAL AUDIO OUTPUT PCM / BITSTREAM 1 AUDIO 2 OUTPUT VIDEO L S-VIDEO TV ANTENNA Y PB/CB COAXIAL INPUT R AUDIO L (L1) VIDEO S-VIDEO PR/CR COMPONENT VIDEO OUTPUT 11 10 9 8 7 1. AC Power Cord 7. TV ANTENNA OUT jack Connect to a standard AC outlet to supply power to this Use to connect an antenna cable to pass the signal unit. from the TV ANTENNA IN to your TV monitor. 2. AUDIO OUTPUT jacks 1, 2 8. S-VIDEO INPUT jack(LINE1) Use to connect a TV monitor, AV receiver or other Use to connect the S-Video output of external equip- equipment with standard audio cables. ment with an S-Video cable. 3. VIDEO OUTPUT jack 9. VIDEO INPUT jack(LINE1) Use to connect a TV monitor, AV receiver or other Use to connect external equipment with a standard equipment with a standard video cable. video cable. 4. S-VIDEO OUTPUT jack 10. AUDIO INPUT jacks(LINE1) Use to connect the S-Video input of a TV monitor, AV Use to connect external equipment with standard receiver or other equipment with an S-Video cable. audio cables. 5. COMPONENT VIDEO OUTPUT jacks 11. COAXIAL DIGITAL AUDIO OUTPUT jack Use to connect a TV monitor with component video Use to connect an AV receiver, Dolby Digital decoder inputs with component video cables. or other equipment with a coaxial digital input jack 6. TV ANTENNA IN jack with a digital coaxial cable. Use to connect an antenna. Note • Do not touch the inner pins of the jacks on the rear panel. Electrostatic discharge may cause permanent damage to the DVD recorder. • This unit does not have an RF modulator. 8