Sharp FU-40SES Operation Manual - Page 10

PREPARATION Be sure to remove the power plug from the wall outlet. INSTALLING THE FILTERS To maintain the quality of the filters, they are installed in the main unit within polyvinyl bags. Be sure to remove the filters from the polyvinyl bags before using the unit. 1 Remove the filters 1 Place the unit facing up Place the unit on a table, etc., so that the stand does not contact the surface. 2 Remove the front panel Press in the hook on the bottom of the front panel and lift to remove. 2 Soft cloth Table, etc. Front panel 2 Place so stand does not touch surface 1 1 Hook 1 Prefilter 3 Remove the pre-filter, and then remove the staminapower carbon (black) and HEPA filter (white) that are inside the polyvinyl bags. Stamina-power carbon INSERTING BATTERIES IN THE REMOTE CONTROL 1 Remove the back cover Press and slide the back cover to remove. 2 Insert batteries Insert batteries with and as shown below. 3 Close the back cover About the batteries • The battery life is about 1 year. Replace the batteries when the remote control becomes inoperative. • Incorrect usage of the batteries may cause battery fluid leakage and/or damage. Take caution of the following when handling: • When replacing the batteries, replace both batteries with new ones of the same type. (Use AA alkaline batteries (2 units) or AA manganese batteries (2 units).) • When not using the unit or remote control for an extensive period, remove the batteries. This prevents malfunction of the remote control from battery fluid leakage. * The included batteries are for initial use only and may deplete before 1 year. E-8