Sharp HT-SB300 HT-SB300 Operation Manual - Page 18

Preparation for Use HT-SB300 Remote control ■ Battery installation This product contains a CR Coin Lithium Battery which contains Perchlorate Material - special handling may apply, California residents, see www.dtsc.ca.gov/hazardouswaste/perchlorate/ 1 Insert pin into the hole as shown and pull to open the battery holder. Pin Back of remote control 2 Remove the old battery from the battery holder, insert the new battery and then slide the battery holder back into the remote control. Battery holder Battery type Locking tab Polarity (+) symbol Positive (+) side up Caution: ● Do not use rechargeable battery (nickel-cadmium battery, etc.). ● Danger of explosion if battery is incorrectly replaced. ● Replace only with the same or equivalent type. ● Batteries (battery pack or batteries installed) shall not be exposed to excessive heat such as sunshine, fire or the like. ● Installing the battery incorrectly may cause the speaker to malfunction. Notes concerning use: ● Replace the battery if the operating distance is reduced or if the operation becomes erratic. Purchase "CR 2025", coin lithium battery. ● Periodically clean the transmitter on the remote control and the sensor on the speaker with a soft cloth. ● Exposing the sensor on the speaker to strong light may interfere with operation. Change the lighting or the direction of the speaker if this occurs. ● Keep the remote control away from moisture, heat, shock, and vibrations. ■ Test of the remote control Point the remote control directly at the remote sensor on the speaker. The remote control can be used within the range shown below: Press the ON/STAND-BY button. Does the power turn on? Now, you can enjoy your system. Remote sensor Precautions for battery use: ● Remove the battery if the speaker will not be used for long periods of time. This will prevent potential damage due to battery leakage. 18 15˚ 15˚ 8" - 20' (0.2 m - 6 m)