Sharp HT-SB300 HT-SB300 Operation Manual - Page 21

Dolby Pro Logic II System expanding 2ch stereo sound to more spacious sound. When setting Dolby Virtual speaker to "ON", Dolby Pro Logic II is activated to enjoy the stereo sound effect. Lights up when Dolby Pro Logic II is activated. ■ Subwoofer level control The speaker level can be adjusted. To increase the level, press the SUBWOOFER LEVEL + button. To decrease the level, press the SUBWOOFER LEVEL - button. -5 -4 ... 4 5 Note: When sound from the speaker is distorted, decrease the subwoofer level. ■ Bass control 1. Press the BASS/TREBLE button to select "BASS". 2. Within 5 seconds, press the VOLUME (+ or -) button to adjust the bass. -5 +5 ■ Treble control 1. Press the BASS/TREBLE button to select "TREBLE". 2. Within 5 seconds, press the VOLUME (+ or -) button to adjust the treble. -5 +5 ■ Function On speaker: When the FUNCTION button is pressed, the input source will change. Press it repeatedly to select desired input source. On remote control: Press the LINE button repeatedly to select "L1" (LINE IN 1 input) or "L2" (LINE IN 2 input). LINE IN 1 LINE IN 2 DIGITAL 1 HT-SB300 Basic Operation DIGITAL 2 Note: The backup function will protect the memorized function mode for a few hours should there be a power failure or the AC power cord becomes disconnected. Auto power on function: When you press the LINE / DIGITAL 1 / DIGITAL 2 button on the remote control, the speaker will turn on at the selected function. Auto power off and auto detect signal: ● If no analogue signal is detected within 1 minute or if "d1"/ "d2" display is blinking for 30 seconds during power on, the speaker will automatically go to stand-by mode. The STANDBY indicator turns orange. ● The speaker will automatically power ON if it detects audio signal from connected equipment. 21