Sharp HT-SB300 HT-SB300 Operation Manual - Page 23

Error indicators and warnings When you fail to perform operations properly, the following messages are displayed on the speaker. Display or Meaning ● Malfunction of the surround circuit. Place the speaker away from noise source and plug the AC power cord into another AC outlet. (*) or ● When there is no input signal. Play back the connected equipment. ● Nonstandard signal. Cannot be recognized. Signals other than DOLBY or DIGITAL, DTS, Linear PCM cannot be recognized. ● Poor connection of the digital audio input terminal. Turn off the unit and check if the cable is connected properly. (Display blinks continuously) ● When the protection circuit is activated. Power indicator (blinks red) (*): Should the same message appear even if the speaker is unplugged and plugged in or is set to the stand-by mode and on again, contact your local dealer where you purchased the speaker. Specifications HT-SB300 References As part of our policy of continuous improvement, SHARP reserves the right to make design and specification changes for product improvement without prior notice. The performance specification figures indicated are nominal values of production speaker. There may be some deviations from these values in individual speaker. ■ General Power source DC IN 12V 4A: AC/DC adaptor (AC 100 - 240 V ~ 50/60 Hz) Power consumption 11 W Maximum output 32 W power Speaker 2.1-way Speaker System Front Speakers: 1-1/2" (38 mm) Full Range Subwoofer: 2-1/4" (57 mm) Woofer (x4) Input terminals Analog input (LINE 1): RCA type x 1pair (L/R) Analog input (LINE 2): Stereo mini jack Ø 3.5 mm Coaxial digital input (DIGITAL 1): RCA type x 1 Optical digital input (DIGITAL 2): Square type x 1 Audio output terminals Subwoofer Pre Out: 10 kOhms Dimensions Width: 31-1/2" (800 mm) Height: 3-3/4" (96 mm) Depth: 2-3/4" (70 mm) Weight 4.10 lbs. (1.85 kg) 23