Sharp HT-SB350 HT-SB350 Operation Manual - Page 8

System preparation (continued) ■ Driving screws SHARP designed the speakers so you may hang them on the wall. Use proper screws (not supplied). See below for size and type. 1/8" (3.2 mm) 3/16" (5 mm) 3/8" (9 mm) Min. 7/8" (22 mm) ■ Wall mount angle fixed to the wall (Horizontal position)  Fix the pattern paper to the wall in horizontal position as below. 44 mm 509 mm Wall surface 44 mm 29 mm Wall surface Wall mount angle Wall surface Note: Make sure all screws are fully tightened. (screws are not supplied) ■ Installing the sound bar  Align the wall mount slot at the unit to the wall mount angle.  Slot the unit into the wall mount angle. 3 Fix them securely. Wall surface 29 mm Pattern paper  Make a hole on the wall following the screw point marks on the pattern paper by using a drill. 1-1/4" (32 mm) 3/8" (8-9 mm) Wall surface 3 Fix a wall mount plug into the hole using a hammer, until it is flush with the wall surface. 1-1/4" (32 mm) 3/8" (8-9 mm) Wall surface  Screw the wall mount angle to the wall as shown in the illustration. (Total screw is 8 pieces) Wall mount angle Wall surface Wall mount angle (screws x 4) (screws x 4) E-