Sharp HT-SB350 HT-SB350 Operation Manual - Page 9

Placing the sound bar Installation image: TV Place the unit as shown. VCR DVD player Notes: ● As the sound from the speaker is omni-di- rectional, you can place it anywhere you like. However, it is recommended to place it as close to the TV as possible. ● The front panel of the unit is not removable. Caution: ● Do not change the installation direction when the unit is turned on. ● Do not stand or sit on the unit as you may be injured. ■ Using other subwoofer You can connect a subwoofer with an amplifier to the SUBWOOFER PRE OUT socket. Audio cable (commercially available) Sound bar Audio signal To audio input socket To SUBWOOFER PRE OUT socket Commercially available subwoofer (amplifier built in) Note: No sound is heard from the subwoofer without a built-in amplifier. Falling prevention Safety wires (not supplied) are useful to prevent the unit from falling off the table. Loop the safety wires (not supplied) into each hole as shown and tie the safety wires to the LCD TV stand. Sound bar connections to TVs Caution: Turn off all other equipment before making any connections. Tuner receiving for other audio system ● Placing the antenna near the unit AC power cord may cause noise pick up. Place the antenna away from the unit for better reception. Notes: ● To connect to TV, use either digital or analog terminals located at the rear of the unit. ● Refer the operation manual of the equipment to be connected. ● Fully insert the plugs to avoid fuzzy pictures or noises. E-