Sharp LC-20D30U LC-20D30U Operation Manual - Page 39
Connecting a PC
View all Sharp LC-20D30U manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 39 highlights
Connecting a PC Viewing an Image from a PC Use the INPUT5 (PC-IN) terminals to connect a PC. A • The PC input terminals are DDC1/2B-compatible. • Refer to page 39 for a list of PC signals compatible with the System. • Make sure to select the same signal values for the output signal of a PC and the input signal of the LCD TV set before connecting with the PC. (See pages 38 and 39.) • Depending on the PC being used, images may not be shown without converting the output signals into external output. Please refer to your PC's manuals regarding converting to external output. To ANALOG RGB To ANALOG output terminal RGB terminal RGB cable (supplied) PC ø 3.5 mm stereo minijack cable (commercially available) To Audio output To AUDIO terminal input terminal Connecting the RGB cable Ferrite core • Connect the RGB cable making sure that it fits correctly into the terminal. Then, firmly secure the connectors by tightening the screws on both sides of the plug. • Do not remove ferrite cores attached to the RGB cable. Signal names for 15-pin mini D-sub connecter 543 21 10 9 8 7 6 15 14 13 12 11 Pin No. 1 2 3 4 5 Signal name R G B Not connected CSYNC Pin No. 6 7 8 9 0 Signal name GND (Ground) GND (Ground) GND (Ground) +5V GND (Ground) A • Pin No. 5 is not used for inputting the signal. • Pin No. 9 is not connected with the supplied RGB cable. Pin No. q w e r t Signal name Not connected SDA HD VD SCL Displaying an Image from a PC To view an image from a PC, perform the following procedure. 1 Select the INPUT5 (PC) mode using INPUT on the remote control or the LCD TV set. (See page 18.) 2 Select the PC input signal. (See page 38.) 3 Adjust the "FINE SYNC." items if the PC image does not come in clearly. (See page 38.) 37