Sharp LC 32SB24U Operation Manual - Page 13

Direct Button Operation _REEZE r_E_U You can change channels by pressing CHA/V or 1_9, * (DOT). Examples: To select a i or 2-digit channel number (e. g., Channel 5): Press 5 _ ENT. To select a 3-digit channel number (e. g., Channel 115): Press 1_ 1 _ 5_ ENT, To select a 4-digit channel number (e. g., Channel 22.1): Press 2 _ 2 _ * (DOT) _ 1 _ENT o When selecting a 1-digit channel number, it is not necessaly to press 0 before the number, o When you enter 0-9 only, channel selection will be made if there is no operation within a few seconds. o If you push "O" by itself, nothing will happen. Complete the above steps within a few seconds, When you enter 0-9 and * (DOT), channel selection will be made if there is no operation within a few seconds. Mutes the current sound output. Press MUTE. • "r,_" will be displayed on the screen for 30 minutes, and the sound is silenced Within 80 minutes of pressing MUTE, mute can be canceled by using one of the methods below Mute will be canceled ifyou press VOL +/- or MUTE. • Mute will be canceled after SOminutes have passed, However, the TV will not suddenly output a loud sound as the volume level is set to 0 automaticafly, Allows you to set a time when the TV automatically switches to standby. Press SLEEP. The remaining time displays when the sleep timer has been set • Each time you press SLEEP, the remaining time switches as shown below. Off 1301 t 60 _* 90 i 120 = When set, the time automatically starts counting down Ifyou want to ad ust the sleep timer, you can press SLEEP twice then change the time setting. • Five minutes before the time expires, the remaining time displays every minute Select "Off" by pressing SLEEP to cancel the sleep timer. The TV will enter standby when 1he remaining time reacheszero = When the sleep timer is set, its indicator on the TV lights red Allows you to capture and freeze a moving you are watching. Press FREEZE. • A moving image is captured. • Press FREEZE again to cancel the function image that When this function is not available, "No displaying still image available," will display, The still image automatica]ly goes out after 30 minutes. Ifyou are usin/g the freeze function and a broadcast activates the V-CHP BLOCK, the freeze function will be canceled and a V-CHP BLOCK message will appear, You can change the volurrle by pressing VOL+/- on the TV or on the remote control unit. To increase the volume, press VOL + o To decrease the volume, pless VOL - I a..2..o...l.. Audio status • When "Output Select" is set to "Variable", the indicator on the screen changes as shown below I _1 To view external source images, select the input source using INPUT on the remote control unit or on the TV. 1 Press _NPUT. A list of selectable sources appears. 5' Press _NPUT again or press _/_' input source. to select the An image from the selected source automatically displays Each time _NPUT is pressed, the input source toggles, ® [f the corresponding inpulis not plugged in,you cannot change the input Be sureto connect the equipment beforehand See page 1f for external equipment connection • Press PC to switch to an image from the PC • See page 25 for details on the Output Select function 13