Sharp LC 32SB24U Operation Manual - Page 28
Appendix - problems
UPC - 074000370913
View all Sharp LC 32SB24U manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 28 highlights
Appendix Problem • NO power Possible Solution Check if you pressed POWER on the remote control unit. (See page 12) If the indicator on the %/does not light up, press POWER on the %/ is the AC cord disconnected? (See page 7,) • Has the power been turned on? (See page 12) • Unit cannot be operated • External influences such as lightning, static electricity, may cause improper ope/ation. in this case, operate the unit affer first turning oft the power of the %/or unplugging the AC cord and replugging it in after 1 or 2 minutes Remote control unit does not operate • Picture is cut off/with sidebar screen Are batteries inserted with polarity ( J, ) aligned? (See page 8) Are batteries worn out? (Replace with new batteries.) Are you using it under stlong or fluorescent lighting? is a fluorescent light ilk_minated near the remote control sensor? • Is the image position corlect? (See page 21 ,) Are screen mode adjustments such as picture size made correctly? (See page 16.) Stlange color, light color, or color misalignment Adjust the picture tone. (See pages 18 and 19) • Is the room too bright? The picture may look da/k in a room that is too bright. Check the input signal setting (See page 21 ) Power is suddenly turned off Is the sleep timer set? (See page 13) • Check the power contlol settings. (See page 20) The unit's internal temperature has incleased Remove any objects blocking vent or clean, • NO picture • Nosound • The %/sometimes makes a clacking sound • Is connection to other components cor/ect? (See page 11 ) Is correct input signal source selected after connection? (See page 25) • Is the cor/ect input selected? (See page 25,) Is pictule adjustment correct? (See pages 18 and 19) • Is "On" selected in "Audio Only"? (See page 24.) o Is a nomcompatible signal being input? (See page 30,) • Is the volume too low? (See page 13) Is "Variable" selected in "Output Select"? (See page 25) Have you pressed MUTE on the remote contlol unit? (See page 13) • This is not a malfunction. This happens when the cabinet slightly expands and contracts according to change in temperature This does not affect the %/'s performance The error message about reception of broadcast The example of an error message displayed on a screen Failed to receive broadcast, Error code E202 No b/oadcast now, E208 Possible Solution • Check the antenna cable Check that the antenna is correctly setup. • Check the broadcast time in the program guide, Cautions regarding use in high and Jow temperature environments • When the unR is used in a low temperatu/e space (eg. room, office), the picture may leave trails or appear slightly delayed This is not a malfunction, and the unit will recover when the temperature returns to normal • Do not leave the unit in a hot or cold location, Also, do not leave the unit in a location exposed to direct sunlight or near a heater, as this may cause the cabinet to defofrrl and the Liquid Crystal panel to malfunction, Storage temperature: 4°Fto 140°F( 2O°Oto I 6O°C) 28