Sharp LC 32SB24U Operation Manual - Page 6

QUICK REFERENCE Before attaching (or detaching) the stand, unplug the AC cord from the AC iNPUT terminal. Before perfo/ming work spread cushioning over the base area to lay the TV on This will prevent it from being damaged. • Attach the stand in the correct direction. Do not remove the stand from the 1_/unless using an optional wall mount bracket to mount it. • Be sure to follow the instructions. Incorrect installation of the stand may result in tbe TV falling over. 1 Confirm that there are 9 screws and a hex key supplied with the stand unit. 2 Attach the supporting post for the stand unit onto the base using the box for the stand unit as shown below. Hoxkoy_ @ C'r_= Y4_l'_f/f_% • This TV sbould be mounted on tbe wall only with the AN-gTAG5 (SHARP) wall mount bracket. The use of other wall mount brackets may result in an unstable installation and may cause serious injuries. = Installing the TV requires special skill that should only be performed by qualified service personnel. Customers should not attempt to do the work themselves. SHARP bears no responsibility for improper mounting or mounting that results in accident or injury. Using an optional bracket to mount the "rv • You can ask a qualified service professional about using an optional AN 37AG6 bracket to mount the TV to the wall. • Carefully read the instructions that come with the bracket before beginning work. f Hanging on the wall AN 37AG5 wall mount bracket. (See the bracket instructions for details.) 3 r_ Insert the stand into the openings on the bottom of the TV. "2', Insert and tighten the 4 screws into the 4 holes on the rear of the TV. _'f_ _ _'_s ....... Vertica] mounting Angular mounting About setting the 13/angle 0/5/10/15/20 < LC-32SB24U The center of the display: _/,_ il/ch (4.0 mm} ul/der the "A" position. LC-37SB24U The center of the display: 1/4 inch (6.0 ram) above the "A" position. Refer to the operation manual d AN 37AG5 for details. Soft c * To detach the stand, perform the steps in reverse order Detach the cable clamp on the rear of the %/when using the optional mount bracket. Due to the terminal configuration on this %/, when you walPmount this model, make sure there is enough space between the wall and the %/for the cables, To use this %/mounted on a wall, first remove the adhesive tape at the 4 locations on the rear of the %/, and then use the screws supplied with the wall mount bracket to secure the bracket to the rear of the %/