Sharp LC 32SB24U Operation Manual - Page 21
On-Screen, Display - blinking power
UPC - 074000370913
View all Sharp LC 32SB24U manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 21 highlights
On-Screen Display Menu This setting allows you to skip the HDMI or PC-IN Input ("Input 4 (HDMI)", "Input 5 (HDMI)" and "Input 6 (RGB)") on the Input Selection operation. Yes: Skips the input, No: Does not skip input. Lets you set the input terminal displayed when using the INPUT SOURCE menu or channel display. Press &IT/_/11_ mode. to select the new name for the input You cannot change labels if the INPUT SOURCE is _V Some input signals may have to be registered manually to display properly. The pair of input signals (resolutions) in the list below is not distinguishable when received. In such a case, you have to set the correct signal manually. After setting once, it will display when the same signal (resolution) is input again. El 024 x 768 1360 x 768 J You can only select the "Input Signal" on the Setup menu when receiving one of the 2 input signals listed above. For automatically adjusting the PC image. Yes: Auto Sync. starts and "Now adjusting the image _' displays, No: This function does not work. When Auto Sync, is successful, "Completed" displays, If not, Auto Sync. failed Auto Sync. may fail even if "Completed" displays Auto Sync. may fail if the computer image has low resolution, has unclear (black) edges, or is moved while executing Auto Sync. • Be sure to connect the PC to the TV and switch it on before starting Auto Sync. Ordinarily you can easily adjust the picture as necessary to change image pos_ion using Auto Sync. In some cases, however, manual adjustment is needed to optimize the image. N-Pos.: Centers the image by moving it to the left or right, V-Pos.: Centers the image by moving it up or down Clock: Adjust when the image flickers with vertical stdpes, Phase: Adjust when characters have low contrast or when the image flickers For resetting all Fine Sync. adjustment items to the facto/y preset values, press h,/T to select "Reset", and then press ENTER k is not necessa/y to adjust the "Clock" or "Phase" when a digital signal is being input, so it cannot be selected The default cursor position may not be in the center because the screen position variable ranges may be asymmetrical. • The screen position variable ranges depend on the View Mode or the signal type. The ranges can be seen on the position setting screen For adjusting a picture's horizontal and vertical position. N-Pos.: Centers the image by moving it to the left or right, V-Pos.: Centers the image by moving it up or down • For resetting adjustments to the factory preset values, press A/_' to select "Reset", and then press ENTER. • When connecting a PC to the HDMI terminal, the image position will be automatically adjusted It cannot be manually adjusted. The screen position variable ranges depend on the View Mode or the signal type. The ranges can be seen on the position-setting screen. Adjustments are stored separately according to input source You can also select a language from the Setup menu. Select from among 3 languages: English, French and Spanish. If complex adjustments are made and the seltings CaRROt be restored to noRY/al, you can reset the settings to the factory preset values. 1 "Return to the factory preset values" displays on the screen. If you have already set the Secret No, input the 4-digit secret number here See page 22 for setting a secret number 2 Select "Yes". "Now, TV will restart automatically OK?" displays on the screen 8 Select "Yes". "Now initializing.,," displays on the screen and blinks, After the reset has been completed, the power shuts off and then comes back on The screen will have returned to its original settings, The Channel Setup settings will not be changed The Language settings will not be changed. The Secret number settings will not be changed The TV Location Settings will not be changed