Sharp LLM15X1 Operation Manual - Page 14

Connecting the monitor to a computer CAUTION! - When connecting, ensure that the monitor and all the equipment you are connecting to it are switched off. - Be careful not to over bend the cable or add extension cords as this could lead to a malfunction. - When using the monitor for the first time or after having changed the system settings during use, perform an automatic screen adjustment (see page E20). See page E8 for information on removing/replacing the terminal cover. PC audio cable (accessory) PC analog signal cable (accessory) Analog RGB terminal (Mini D-sub15 pin 3 rows) Paying attention to the connector direction, firmly insert the signal cable straight into the connector, and Audio output terminal then tighten the screws at both ends. The monitor's speakers will play the computer's audio when you connect the two devices with the PC audio cable accessory. Notes: - Depending on the computer or OS, you may have to install the set-up information for the monitor. (See page E35.) - When connecting to a notebook and the notebook computer's screen is set so that it is displaying at the same time, the MS-DOS screen may not be able to display properly. In this case, change the settings so that only the monitor is displaying. If connecting to a D-sub15 pin 2 row Apple Power Macintosh, attach a Macintosh conversion adapter (commercially available) to the analog signal cable. Power Macintosh Macintosh conversion adapter E12