Sharp MS702 Operation Manual - Page 12

■

Recording from a tuner or a CD (Manual recording)

●

Manual recordings can be started and stopped as you like.

Recordings can not be made in the

following situations:

●

Recording on a playback-only Mini-

Disc (commercially available music)

●

If a Minidisc is protected against ac-

cidental erasure (page 9)

About the recording level:

●

If the recording level is too low, the

playback sound volume may be too

low to hear well. If it is too high, the

playback sound may be greatly dis-

torted. Since digitally recorded CDs

have a large dynamic range (the

volume can vary tremendously from

very soft to extremely loud), do not

set the recording level any higher

than is necessary.

Precautions when recording:

●

Do not jar or bump the main unit

while

recording.

Otherwise,

the

recording may be unusable.

●

Depending on the strength and type

of playback signal in the original

recording, the new recording may

not begin or pause at the correct

point when in the synchro mode. If

this happens, try making a manual

recording.

Precautions when inserting a Mini-

Disc:

●

To insert a Minidisc, push on the

middle of the edge of the disc while

holding it parallel to the main unit.

●

If any resistance is felt, do not try to

force the MiniDisc into the unit. It

may cause more problems. If resis-

tance is felt, remove the MiniDisc

and try reloading it.

Notes:

●

Whenever any button is pressed, the

remote control display will light for

about 4 seconds.

●

The REC button does not light.

1

Put the unit in the recording stand-by

mode. (Perform steps 1 - 4 in the

“Synchro recording” section.)

2

Press the

button.

●

Recording will start.

●

To record from a CD, press the

button, and then start playback on the

equipment connected to this unit.

●

Track numbers can be created while

recording. (Page 17)

To interrupt recording:

Press the

button while recording.

●

The unit will enter the recording stand-

by mode.

●

To resume recording, press the

button again.

The track number will be increased by

one each time you interrupt a record-

ing.

To stop recording:

Press the

■

/:OFF button.

●

If the unit is left alone after the record-

ing has stopped, the power will be

turned off about 2 minutes later.

After recording:

Press the

■

/:OFF button while in the stop

mode.

●

After the track number has been written

on the disc, the power will be turned off

automatically. (For details about the

TOC, see page 20.)

To remove the MiniDisc:

Turn off the power and move the EJECT

lever in the direction indicated by the

arrow.

11

MD-MS702

Sharp MS702 Operation Manual - Page 12

Recording from a tuner or a CD Manual recording, To interrupt recording, To stop recording, After

Page 12 highlights